Maintenance; Lights - Thermador PROFESSIONAL Série Guide D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour PROFESSIONAL Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance

Lights

Turn off the lights and blower. Allow the lights to cool before
handling. If new lights do not operate, be sure lights are
inserted correctly before calling for service.
Turn power off at breaker before removing a damaged
bulb. Do not touch the bulbs immediately after use. The
bulbs will remain hot for several minutes.
WARNING:
Make sure the appliance and the lights are cool and
power to the appliance has been turned off before
replacing the light bulb(s). Failure to do so could
result in electrical shock or burns.
The lenses must be in place when using the
appliance.
The lenses serve to protect the light bulb from
breaking.
The lenses are made of glass. Handle carefully to
avoid breaking. Broken glass can cause an injury.
CAUTION:
Halogen Light Replacement
Bulb
Figure 5: Halogen Light Replacement
1. Using a flat edge from a screwdriver or equivalent tool,
pry loose the lens cover, as shown in Figure 5.
2. Pull damaged bulb straight out from the socket to
remove.
3. Replace with a new 120 V, 40W (maximum) bulb with
G-9 base. Press pins in bulb base straight into socket
until fully seated. Follow package directions and do not
touch new light with bare hands; the oils from your skin
can reduce the longevity of the bulb.
4. Reinstall the lens cover.
Lens
English 7

Publicité

Table des Matières
loading

Table des Matières