SOLIS VAPO-FLÛTE Mode D'emploi page 46

5. R EM OTE -CO N TR O L
•
Thanks to the wireless remote-control you can com-
fortably operate your appliance within a radius of
20 m. Open the battery compartment on the back
of the remote and insert a button cell battery (type
CR2032). Make sure that the polarity is correct
and then close the battery compartment. On the
remote-control there is an ON/OFF button
and also and
you can switch the Vapo-Flûte on, with the
button you can increase the atomization level and
with the button you can reduce the atomization
level. If you hold the buttons constantly, you can
reach the maximum or minimum atomization level.
6. AU TO MAT I C S H UT O FF WH E N W AT E R T ANK IS E MPT Y
•
If the water tank is empty, the appliance will automatically stop after 5 to 20
minutes to protect the appliance. As an acoustic signal you will hear a "BEEBEE".
If you have not refilled the water on time, the indicator light blinks red until the
water is filled up again.
7. S W ITC H IN G O FF A P P LI A N CE
•
Switch the appliance off (press the touch button quickly, less than 1 second).
The music sequence "MI RE DO" sounds briefly, then the indicator light goes out.
•
Pull out the plug.
•
Remove the water reservoir from the base and open the cap. Empty the water
and clean the reservoir.
•
Allow all of the parts to dry and then store the appliance.
46
buttons. With the button