Publicité
4.4
Installation diagram
6
Fig. 4
[1] Appliance support input
[2] Appliance support output
[3] Cold water from the distribution network
[4] Hot water for the distribution network
[5] Hot water from the solar system
[6] Solar colector
4.5
Commissioning
Prior to commissioning the Solar Kit, the installation needs to
be cleaned in order to remove any dirt that has accumulated
during assembly.
Not removing all dirt may affect the product's
performance and the manufacturer's
warranty.
Use filters of suitable capacity at the distribution network's
water inlet. In those areas that are subject to very aggressive
water, make sure that the water can be treated prior to entering
the Solar Kit.
Put the Kit into service
▶ open the valves allowing water to flow through.
▶ check for leaks at all connecting points.
5
Use
5.1
Operation
The Solar Kit does not have any type of electrical connection,
which is why its commissioning operation becomes extremely
simple; just:
Solar Kit – 6 720 608 087 (2022/06)
2
1
4
3
5
6720608350-03.3Av
▶ open the valves allowing water to flow through.
After this procedure, whenever a hot water tap is opened, one
of two situations will occur:
1. The solar system's water temperature will exceed 45 °C
The deflector valve will close the water inlet on the support
appliance and the water will be channeled to the mixing valve.
There, the water will be mixed with cold water from the
distribution network, to the defined adjustment temperature
2. The solar system's water temperature will be lower than
45 °C
The deflector valve will close the water inlet to the mixing valve
and the water will be channeled to the support appliance,
where its temperature will be increased. The water that will
result from this process will then pass through the mixing valve,
where it will be mixed with cold water, to the defined
adjustment temperature.
5.2
Adjusting thermostatic valves
The thermostatic valves included in the Solar Kit come sealed
and are both preset to 45 °C. Should you wish to modify these
settings, please contact a qualified technician.
WARNING:
if this specification is modified by a non-
accredited technician, the Solar Kit may not
work properly, as a result.
6
Maintenance
It is essential that access to the Solar Kit be kept clear, so as to
prevent any hindrance to any eventual maintenance that may
be required.
CAUTION:
maintenance shall be performed only by an
accredited technician.
Use
7
Publicité
