ulsonix AIRCLEAN 10G Manuel D'utilisation page 36

NOTE! Upon completion of treatment ventilate the room for 15 to 30 minutes. Do not
enter the room for at least 2 hours after completion of the ozone treatment. PLEASE
NOTE! Use the device only in empty rooms! Ozone is an irritant gas, it may cause
damage to biological membranes through radical reactions with their constituents. If
the characteristic ozone smell is still present in the room which was treated with ozone,
first make sure that the device is switched off then leave the room and/or ventilate it.
3.4.
Cleaning and maintenance
a) Always unplug the device before cleaning it.
b) Use only non-corrosive cleaners to clean the surface.
c) Store the unit in a dry, cool place, free from moisture and direct exposure to
sunlight.
d) Do not spray the device with a water jet or submerge it in water.
e) Do not allow water to get inside the device through vents in the housing of the
device.
f) The device must be regularly inspected to check its technical efficiency and
spot any damage.
g) Use a soft, damp cloth for cleaning.
h) For an effective use it is suggested to replace the Ozone Plates every 6 month.
FUSE REPLACEMENT
PLEASE NOTE! The fuse should be replaced by a specialist!
1) Disconnect the device from power supply.
2) Disconnect the power cord and remove the fuse holder.
EN