Philips S9000 Serie Manuel D'instructions page 19

'Unplug for use' symbol
Charging in the charging stand
How do I use my appliance and the attachments?
Shaving
The 'unplug for use' symbol displays to remind you to
disconnect the appliance from the wall socket and
remove the small plug from the appliance before you
switch it on.
1 Make sure the appliance is switched off.
2 Put the small plug in the charging stand and put the
supply unit in the wall socket.
3 Place the appliance in the charging stand.
Specific models only: The light ring on the bottom of
the charging stand lights up and rotates quickly.
- After approximately 5 minutes, the light ring
rotates slower. The battery now contains enough
energy for one full shave.
- As the appliance continues to charge, the light
ring becomes brighter and rotates slower.
- When the appliance is fully charged, the light ring
lights up fully and stops rotating.
Warning: Always check the appliance and all
accessories before use. Do not use the appliance
or any accessory if it is damaged, as this may cause
injury. Always replace a damaged part with one of
the original type.
You can use this appliance either wet or dry, or even in
the shower. For a wet shave, apply some water and
shaving foam or gel to your skin and rinse the shaving
heads under the tap with warm water before following
the steps below.
1 Switch on the appliance.
19
English