Télécharger Imprimer la page

Electrolux EWUS018B7B Notice D'utilisation page 15

Masquer les pouces Voir aussi pour EWUS018B7B:

Publicité

Problem
The compressor operates continual‐
ly.
The light does not work.
Too much vibration.
The appliance is noisy.
Water flows on the rear plate of the
appliance.
Water flows inside the wine cabinet.
Water flows inside the wine cabinet.
The temperature in the wine cabinet
is too low or too high.
If the advice does not lead to the desired
result, call the nearest Authorised
Service Centre.
Possible cause
There is no voltage in the mains
socket.
The circuit breaker tripped or a
blown fuse.
Temperature is set incorrectly.
The room temperature is too high. Refer to the "Installation" chapter.
The door is opened too often.
The door is not closed correctly.
The light is turned off.
The appliance is not plugged in.
The circuit breaker tripped or a
blown fuse.
The lamp is defective.
The light button is not operating.
The appliance is not supported
properly.
The appliance is not supported
properly.
During the automatic defrosting
process, frost melts on the rear
plate.
The appliance drain is clogged.
Products prevent that water flows
into the water collector.
The temperature regulator is not
set correctly.
The door is not closed correctly.
9.2 Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service
Centre.
Solution
Connect a different electrical appliance
to the mains socket, to check if elec‐
tricity is flowing. If not, contact a quali‐
fied electrician.
Turn on the circuit breaker or change
the fuse.
Refer to the "Operation" chapter.
Do not keep the door open longer than
necessary.
Refer to the "Closing the door" section.
Turn on the light. Refer to the "Light
setup" section.
Connect the appliance.
Turn on the circuit breaker or change
the fuse.
Contact the Authorised Service Cen‐
tre.
Contact the Authorised Service Cen‐
tre.
Check if the appliance stands stable.
Check if the appliance stands stable.
This is correct.
Clean the appliance drain hole. Refer
to the "Cleaning the drain" section.
Make sure that products do not touch
the rear plate.
Set a higher or lower temperature.
Refer to the "Closing the door" section.
ENGLISH
15

Publicité

loading