Télécharger Imprimer la page

FLINQ FQC8346 Manuel D'instructions page 6

Publicité

Manuel
EN
Notes and warnings
- If any problems, please restore the lamp to factory default and set it up again from start!
- For Google assistant and Alexa; if these cannot be found, try to disable the FLINQ
function or the home skill app (for Alexa)
- If you need to fully RESET the Smart lamp follow the RESET instructions in the FLINQ
app or the FAQ.
- Do not open the Smart lamp yourself
- This Smart Lamp is not a TOY, Keep away from children!
- Only use this smart lamp with earthed power outlets and not with extension cables
(for charge)
- Do not use with appliances that could cause any fire in unattended use (like irons etc)
- This Smart lamp does not have any safety disconnection
- Any other use as the intended way for this Smart lamp is not validated for any
warranty or liability.
- This Smart lamp is only used for private use
- When the product will not be used for a long time, please place the product in a place
with sufficient sunlight, with a charging time for at least 1 – 3 day's in OFF position.
For keeping the function of the battery, you'd better comprehensively charge the
product in a place with sufficient sunlight for once a month.
- The charging time and charging efficiency of the solar panel may be affected by the
weather and the installation position. Considering the conversion rate of solar power
generation, if the product is used with good sunny weather conditions, it will gain
higher charging efficiency and effectiveness by the solar panel and it's battery.
- When there's sunlight and other lights and if the power switch is OFF, the LED lamp
will not be lightened in day and night time.
- The solar lamp should be installed in the place with sufficient sun light to ensure the
solar panel will absorb sunlight sufficiently, so that the working hours of the solar
lamp will be prolonged.
- If snow or ice is on top of the solar panel please remove it at all time's so the battery
can be charged correctly by the panel.
- This solar light is only used for domestic private and non-commercial use.
- Choose a stable, solid and supportive surface and make sure the lights are set
correctly.
- This lamp is intended for outside use!
- This is not a TOY, keep away from small children below 12 years.
- Do not place or immerse the lamp under water like pools and ponds! It is not FULL
waterproof (IP68).
- Do not use with appliances that could cause any fire in unattended use (like irons
etc.).
- Any other use as the intended way for this device is not validated for any warranty or
liability.
- Do not use the device excessively and do not store them under heavy pressure. The
device is not resistant to extreme heat.
- Do not open or disassemble the lamp yourself, this will void the warranty at all times.
- Do not disassemble, repair or modify the product by yourself as this may result into
an electric shock.
- Do not stand, sit on, jump or throw with the lamp at all times.
- Do not throw this product in the air to avoid damage caused by falling.
- Only use the lamp for its intended designed use as a light.
- Under extreme conditions the battery cells can cause leaking. If that fluid touches the
skin then please clean directly with water and soap. If within the eyes then clean with
water for at least 10 minutes and consult a doctor.
- Never touch the plug contacts with sharp or metal objects.
- Use only the original power supply and original accessories.
- Protect the device from special liquids and vapors
Read and follow all safety instructions
- This IPx4 product is suitable for outdoor use.
- Do not install near a gas or other sources with a similar heating process.
- Do not use the product outside its intended use.
- Read and follow all instructions that are indicated on the product or supplied with it.
- Keep this manual for future reference or for third parties.
Instructions for care and maintenance
When disassembling, carefully remove the product from its location (ground, trees,
bushes, table etc.) to avoid any pressure on the Solar Light that could damage the
component elements. In case of non-use, store the product in a cool and dry place
away from direct sunlight and switch to the OFF position.
NON-Replaceable LED lights!
If the light has reached the end of its life, the lamp must be disposed of in
accordance with local disposal regulations.
FlinQ Smart Outdoor Solar Spot

Publicité

loading