Publicité
Manuel
EN
If snow or ice is on top of the solar panel please remove it at all time's so the battery
can be charged correctly by the panel.The normal use time is up till 8 hours when
the batteries are fully charged but depends on the settings, use, position way, ON/
OFF, light color mode and other settings etc. This use time is tested based basic use/
settings (factory standard settings).
Note: Battery level can be checked by the FLINQ app at all times (except when
empty).
If there's sunlight or other lights on the solar panel, the lamp will not be ON even if the
ON/OFF switch has been turned ON. During testing, other object (paper board, hand or
arm) should be used to cover the complete solar panel, then the lamp will be ON after
turning on the ON/OFF switch (and/or switched ON by APP). Select a location that is not
located close to other light sources, such as for example street lighting, because this
enables the lamp to be switched off automatically when set in AUTO ON setting (by APP).
Battery Warning note
New batteries must be recharged and discharged 3 ~ 5 times before their full function
use time is released. Charge indoors only at room temperature and only under
supervision during daytime. Disconnect from the charger when the battery is fully
charged, as overcharging can shorten battery life. Lithium batteries should only be
charged with constant current/constant voltage (CC/CV). When not in usage, the
charge in a fully charged battery slowly disappears. Do not place the product near a
heat source or expose it to direct sunlight, dust, moisture, rain or mechanical impact.
Try to keep the battery temperature between 0°C and 45°C at all times. If the battery
is too hot or too cold, the product may not work temporarily, even if it is fully charged.
Do not attempt to charge the device when the battery is damaged. Never insert metal
objects in any opening of the (USB) charging port.
The rechargeable battery is built into the device and can be replaced.
Do not throw the battery into the fire, otherwise it may explode. Batteries may also
explode if being damaged, please handle and disposal it according to local conditions
and regulations. After 3 months long storage, need to completely discharged and
recharge for at least 80%. The battery used in this device may present a risk of fire
or chemical burn if mistreated. Do not disassemble, short contacts, heat above 60°C
(140°F), or incinerate. Keep away from children. Do not disassemble and do not
dispose of in fire.
- Ensure that the device do not come into contact with heat sources, hot objects or
naked flames.
- Do not attempt to charge the device when the battery is damaged.
- Leaks from battery cells can occur under extreme conditions. If the liquid gets on
the skin, wash it immediately with soap and water. If the liquid gets into the eyes,
flush them directly with clean water for at least 15 minutes and seek medical
attention.
Pay attention
- Do not charge or store the product in a place below 0°C) or above 40°C), otherwise
the product performance will be reduced.
- It is a normal phenomenon that temperature of the charger rises during charging.
- The product should be charged as soon as it is working to a low battery level; it is
forbidden to leave the product for a long period of time when the battery is low,
which may cause the lithium battery to over discharge and fail to charge normal!
Operation and button modes
The solar lamp can be turned on or off by the ON/OFF button:
1. Light on
Push the ON/OFF button to ON to activate the lamp and the RED led indicator will
turn on. The lamp will turn ON automatically at sunset/night and will go OFF during
sunrise/day (or when the battery is empty) and is done automatically by the internal
light sensor inside the solar panel. Make sure it's connected to the app as well, if
that is done correctly as described below, the light will turn ON and off after 5 sec. if
daytime or stay on during night.
2. Light off
If you push the ON/OFF button to OFF again, the lamp is turned OFF completely. The
solar cells will charge the battery without activating the lamp. Leave the lamp in this
position for at least 2 or 3 sunny days so the battery can be fully charged before using
it or when not in use for longer period of time's to protect the battery.
Tip: Battery level can be checked by the FLINQ app.
Note: Because the device will consume power on standby, if the device is not used
for a long time, please turn off the power switch of the product.
FlinQ Smart Outdoor Solar Spot
Publicité
