Publicité
V1.4
a spark plug wrench or to the recommended torque if listed in
the Specifications.
b.
Non-Gasket Style - Tighten an additional 1/16 turn more with
a spark plug wrench or to the recommended torque if listed in
the Specifications.
7.
Reconnect the spark plug lead to the spark plug.
ADJUSTING THE ENGINE IDLE SETTING
NOTICE! The engine speed is set by the factory. Increasing
the speed too much can damage the engine. Too low a
speed will reduce the engine's efficiency. Have a qualified
technician adjust the engine speed if necessary.
The engine does not have a variable speed option. The engine's idling
speed is adjustable by turning the governor arm screw to lower or
increase the engine output (RPMs).
1.
Remove the shroud and locate the governor arm screw.
2.
Start the engine and wait for it to idle.
3.
The idle screw is above the fuel sediment cup. Tighten the screw
to increase the engine speed. Loosen to reduce speed. See
Specifications for the standard idle speed range.
4.
Shut the engine off and allow to cool.
5.
Reattach the shroud.
CLEANING
WARNING! Only clean engine parts with a nonflammable
solvent, unless instructed otherwise. Keep all ignition
sources away from fuel-related parts. Fumes are flammable
and may cause a burn injury or explosion if ignited.
NOTICE! Do not clean the engine's exterior with a garden
hose or pressure washer. Water can enter the engine
through the air filter or muffler opening and damage the
cylinder.
1.
Allow engine to cool for at least half an hour before cleaning.
Page 21
OHV GAS ENGINE
www.princessauto.com / 1-800-665-8685
8999153
Publicité
