Publicité
Battery assembly and replacement
Do not treat electrical appliances as unclassified municipal waste, use separate collection facilities. For
information on available collection systems, contact your local government.
Do not remove the lithium battery without authorization.
When removing the lithium battery from the vacuum device, please remove all metals such as rings, bracelets,
necklaces, and watches.
The short-circuit current generated by a battery is enough to adsorb the ring (or similar items), causing severe
burns.
Before removing the battery pack, please wear eye protection, gloves, and protective clothing.
Be careful not to touch the wire or any metal parts, or it will cause spark or short circuit.
Do not smoke, spark, or flame near the cleaner, or it will ignite the battery and produce gas.
Avoid exposing the battery to fire or high temperature, otherwise it may cause explosion.
In case of battery leakage, avoid contact with the damaged battery and put it in a plastic bag.
If skin or clothing is in contact with acid, wash immediately with plenty of soap and water.
If the eyes are in contact with acid, rinse the eyes with water for at least 15 minutes and send them to a doctor
for treatment.
Battery replacement (authorized repair centers only):
Pull up the clips located on the upper cover and remove the upper cover from the lower body assembly. Remove the
1.
cartridge filter and set aside.
Use a screwdriver to remove all screws from the circular power box attached to the bottom cover.
2.
4. According to the disassembly steps, reinstall the battery and assemble the charging
parts. Note: (1) if the seal ring is dirty, clean it and install it back into the seal ring groove.
(2) Pay attention to the assembly direction. The six screw holes must be aligned properly to lock the screws.
Warning!
6
Open the battery
3.
cover, As shown in the
figure take out the
battery.
Note: wrap the
connector with
insulating tape
immediately to avoid
short circuit caused by
contact between two
wire terminals.
Publicité
