Publicité
Assembly
A: Upper cover
A-1: Jet Head
B: Cartridge filter
C: Filter
D: Bottom base
E: Charger
F: Hook
G:
Floating foam
( Use it when climbing the slope difficultly,
or when the machine is upside down )
The jet head (A1) rotates 180 degrees as the water flows through
the bottom base (D), the filters (B & C) and the upper cover (A).
The water flow passing through the jet head propels the robot
across the pool floor. Should an obstacle prevent the robot from
moving forward, the jet head turns 180 degrees and sends the robot
in the opposite direction. The debris is collected and stored in the
bottom base (D) of the cleaner as clean water passes through the
filter (C)
Assembly and operation
Charging the cleaner
Use only the original external adapter and charging cable provided.
Make sure the robot and charger ports are clean and dry before installation.
Charge the robot before using it for the first time (about 8 hours)
1. Remove the pin cover from the charging port located
under the cleaner. To avoid losing the cover, attach the
pin cover to the charging cable.
2. Place the charger plug into the charging port at the
bottom of the cleaner, then plug the charger into the
power supply to begin charging the cleaner.
Note: Once the robot starts charging, the indicator
light on the external adapter will turn red. When
the robot is fully charged, the indicator light will
turn green.
3. When fully charged, pull the charger plug out of
the charging port at the bottom of the cleaner.
Securely place the pin cover over the charging
port making sure the port is sealed before placing
the cleaner in the water.
G
F
E
3
A
A-1
B
C
D
Bottom cover body
assembly bottom
Pin cover
Charging port
Charger
Switch
Publicité
