Publicité
TECHNICAL DATA
Type WX371 WX371.X (3-designation of machinery,
representative of hammer drill)
Charger voltage
Rated voltage
No load speed
Impact rate
Number of clutch
position
Max torque
Chuck capacity
Steel
Max.
drilling
Wood
capacity
Masonry
Machine weight
** Voltage measured without workload. Initial bat-
tery voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
***X may be followed by one or two characters. All
models are the same except model number and
trademark. The suffix in models may be number
from "1" to "999" or English letter "A" to "Z" or "M1"
to" M9" which means different package or the vari-
ous of accessories packed in the package.
SUGGESTED BATTERIES AND
CHARGERS
Category
WA3550.1
20V Battery
20V Charger
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
Cordless hammer drill
WX371 WX371.X***
100-240V ~50/60Hz
20V
Max**
0-400/0-1500 min
0-6400/0-24000bpm
18+1+1
40N.m
13mm
13mm
30mm
10mm
1.1kg
Type
Capacity
WA3550
1.5 Ah
1.5 Ah
WA3551
2.0 Ah
WA3551.1
2.0 Ah
WA3553
4.0 Ah
WA3760
0.4 A
WA3880
2.0 A
can assist you and offer advice.
NOISE INFORMATION
A weighted sound pressure
A weighted sound power
K
& K
PA
WA
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined ac-
cording to EN 62841:
Vibration emission
Impact drilling into
value a
concrete
Uncertainty K = 1,5m/s²
Vibration emission
value a
Drilling into metal
Uncertainty K = 1,5m/s²
The declared vibration total value and the declared noise
emission value have been measured in accordance with a
standard test method and may be used for comparing one
tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool is
used especially what kind of workpiece is processed
dependant on the following examples and other variations
on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating cycle
such as the times when the tool is switched off and when
it is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total
working period.
L
: 76,4dB(A)
pA
L
: 87,4dB(A)
wA
3.0dB(A)
= 4,8m/s²
h,ID
= 2,5m/s²
h,D
EN
9
Publicité
