Publicité
6
7
4
1: Light Switch - Press once to turn the LED light on. Press again to turn the light off.
2: LED Light
3: Eco Mode Switch - When turned to the "ON" position, the engine will sense the load
needed and run at the necessary RPM to save fuel.
4: Carbon Monoxide Alarm - A flashing red light indicates a dangerous build up of
carbon monoxide gas has been detected in the area the generator is located. Vacate
this area immediately until it has been aired out. A flashing yellow light indicates a
malfunction in the carbon monoxide sensor and it needs to be serviced.
5: Reset Switch - If the inverter is overloaded, the reset breaker will trip. The engine will
continue to run, but there will be no electrical output from the unit. Unplug your devices,
and push the breaker to reset it.
6: Main Switch - Turn the position to "START" to start the engine, and once the engine is
running, move the switch to "RUN". Switch to "OFF" to stop the inverter.
7: DC Protector: If the generator is overloaded, the DC protector will trip to block current.
8: 8A 12V DC Outlet
9: 120V AC 20A 5-20R Outlet: This outlet can carry up to 20 amps.
10: Ground Terminal: Allows the user to ground their unit.
11: Parallel Connectors: To increase AC power output, the connector sockets are used to
connect the two same type generator with special parallel cables. The connector sockets
are only used for the communication between 2 units and can not be used for AC power
output. Parallel cables are sold separately.
12: AC Protector: If the generator is overloaded, the AC protector will trip to block current.
10
1
HUILE BASSE
main switch
INTERRUPTEUR
DE TENSION
8A
8A
SYSTEM BONDED TO FRAME
SYSTÈME LIÉ AU CADRE
NEED HELP?
BESOIN D'AIDE ?
8
CONTROL PANEL - BE4000i
2
3
9
9
12
5
11
10
Publicité
