Publicité
Instructions for the installer
Installing a domestic appliance can be a
complicated operation which if not carried
out correctly, can seriouslyaffect consumer
safety. It is for this reason that the task
should be undertaken by a professionally
qualifiedperson who will carry it out in
accordance with the technical regulations in
force. In the event that this advice isignored
and the installation is carried out by an
unqualified person, the manufacturer
declines all responsibility for any technical
failure of the product whether or not it
results in damage to goods or injury to
individuals.
BUILDING IN
The hob may be installed in any worktop which is
heat resistant to a temperature of 100°C, and
has a thickness of 25-45 mm. The dimensions
of the insert to be cut out of the worktop are in
shown in Figure 2*.
When there is an accessible space between the
built-in hob and the cavity below, a dividing wall
made of insulating material should be inserted
(wood or a similar material) (Figure 3*).
If the hob is fitted next to a cabinet on either
side, the distance between the hob and the
cabinet must be at least 15 cm; while the
distance between the cut out and the rear wall
must be at least 60 mm for 60 cm hobs (3&4
gases - L1/L2/L3/L6) and must be at least 70
mm for 75 cm hobs (5 gases - L4/L5/L7).
The distance between the hob and any other
unit or appliance above it (e.g. An extractor hood)
must be no less than 700 mm (Figure 4*).
Metal objects in the drawer may reach high
temperatures due to air recirculation. It is
therefore recommended to use an intermediate
wood panel.
Important - The diagram in Figure 1* shows
how the sealant should be applied.
The Hob unit is fitted by attaching the Fixing
Clamps supplied, using the holes at the base of
the unit.
When a 75 cm hob is fitted over a built in oven,
the latter must be fan cooled.
When a 60 cm hob is fitted over a built in oven,
the latter must be fan cooled.
*See "Technical information" section at the end of this manual.
SUITABLE LOCATION
This appliance must be installed in accordance
with the regulations in force and only used in a
well ventilated space. Read the instructions
before installing or using this appliance.
WARNING: Prior to install, ensure that local
distribution conditions (nature of the gas and
gas pressure) and the adjustment of the
appliance are compatible.
WARNING: The adjustment conditions for this
appliance are stated on the label (or data plate)
WARNING: This appliance is not connected to a
combustion products evacuation device. It shall
be installed and connected in accordance with
current installation regulations. Particular
attention shall be given to the relevant
requirements regarding ventilation. For this
reason you should ensure good ventilation
either by keeping all natural air passages open
or by installing an extractor hood with.
EN 8
Publicité
