Publicité
About the dishwasher control panel.
For use with GLC4400 Series
You can locate your model number on the tub wall just inside the door. Throughout this manual, features and
appearance may vary from your model.
Control Settings
Status Indicator Lights
1
The Status indicator lights tell you what's happening while the dishwasher is in operation. The lights
will come ON indicating the sequence of operation the dishwasher is in.
SANITIZED
CLEAN
Cycles
The light above the selected pad will be ON to indicate which cycle has been selected.
2
SANI WASH
NORMAL WASH 5.9 gal., 56 min.
LIGHT WASH
RINSE ONLY
NOTE: Only the SANI-WASH cycle has been designed to meet the requirements of Section 6,
NSF 184 for soil removal and sanitization efficacy
8
1
2
Displayed when cycle has met sanitization conditions. Light remains ON until
door is opened.
Displayed when a wash cycle is complete. The light stays ON as a reminder that
the dishes are clean until the door is opened or until another cycle is selected.
7.3 gal., 97 min.
This cycle raises the water temperature in the final rinse to sanitize your
dishware.
The cycle length will vary depending on the temperature of your inlet water.
NOTE: The SANI-WASH cycle is monitored for sanitization requirements. If the
cycle is interrupted during or after the main wash portion or if the incoming water
temperature is so low that adequate water heating cannot be achieved, the
sanitizing conditions may not be met. In these cases, the sanitized light will not
illuminate at the end of the cycle.
NOTE: NSF certified residential dishwashers are not intended for licensed food
establishments.
This cycle is for medium/heavily soiled dishes and glassware.
6.1 gal., 36 min.
This cycle is for everyday dishes and glassware.
1.2 gal., 6 min.
For rinsing partial loads that will be washed later. Do not use detergent with
this cycle.
3
4
.
1
Publicité
