VINCENT SV-400 Manuel D'utilisation page 34

CONNECTION OF THE LOUDSPEAKERS
If you want to use speaker
cables equipped with spade
lug connectors, every con-
nector screw must be opened
by turning counter clockwise.
After that, the lug must be moved under the screw head. Then,
turn the screw clockwise to fasten the lug to the connector. To
avoid damages to the amplifier, make sure the connection is
tight and no bare metal from the cable lug connector makes
contact with the rear panel or with another terminal.
If no connector is to be used, remove approximately 1 cm length
of insulation from each end of the speaker wire. Twist the braid
in order to avoid short circuits. Turn the fastener on the loudspea-
ker terminal counter clockwise to loosen it and
introduce the bare wire end into the exposed
connector hole. Then turn the fastener clockwi-
se so that the wire is firmly clamped. Make
sure the connection is pretty tight.
A set of headphones equipped with a 6.3 mm jack can be plugged into the socket "PHONES" (2) on the
front of the appliance.
SV-400
By doing this, the loudspeakers are switched off. All headphones with an impedance of between 32 Ohm
and 600 Ohm may be used. Unsuitable headphones with too low impedance may damage the amplifier
or produce such unexpectedly loud volume that your hearing may be damaged. The volume (6-7)(20)
should be reduced for safety reasons before a set of phones is connected.
Vincent Vincent
34 34
CONNECTION OF HEADPHONES