Publicité
4. Inspect the tubing. If you find condensation in the air tube, wash and dry it immediately
or replace the tubing. If you see breastmilk inside the tubing or tubing connectors do not
attempt to wash, clean, or sanitize the tubing or tubing connectors.
5. Should you have any questions or concerns about your parts please contact
Lansinoh® at support@lansinoh.fr for further guidance.
6. To purchase replacement parts for your pump please visit www.lansinoh.fr
WARNING: It is highly recommended not to use any method other than the above-
mentioned cleaning methods.
WARNING: Use caution when cleaning the small white valve. It is important for
proper suction. Do not use excessive force and do not clean with a baby bottle
brush or a nipple brush. Gently wash by hand in hot, soapy water and rinse under
hot running water.
7. Replacing the Rechargeable Battery
1.
Prepare pump by disconnecting the AC power adapter to make sure the pump is
turned off. Then turn the pump over, exposing the bottom of the pump.
2. Remove battery cover by pressing battery cover locking tab downward, pulling tab
back and lifting cover from pump body. Place cover to the side.
3. Disconnect existing battery for Lansinoh® approved/supplied replacement only
(applicable to Item #53351 only)
a. While keeping wires attached to pump and battery, gently remove battery from
pump body exposing the battery
connector.
b. Press the battery connector
locking tab downward while
gently pulling wires.
c. Fully remove and properly
dispose of old battery.
4. Install Lansinoh® Rechargeable
Battery
a. Align battery connector tab with
pump connector slot.
b. Press connector fully into place.
c. Gently tug on wires to confirm
battery connector is fully
installed.
5. Place battery into battery
compartment. The battery can
be placed in one of two positions
with the wires at either the top or
bottom.
a. Ensure battery wires are placed
either at the top or bottom of
battery compartment making
sure wires do not interfere with
pump body.
b. Ensure battery wires will not
interfere with the battery cover
by gently pressing the wires into
battery compartment.
6. Reinstall Battery Cover
a. Slide the two battery cover bottom tabs into the housing slots.
Release
button
Battery
connector
11
Publicité
