Use - Maxx 3186-1 Mode D'emploi

Use

PLEASE NOTE!
❐ The blades are sharp! Be careful when handling the cross-blade and fl at-blade
attachment in order to prevent any cut injuries.
❐ Never reach into the mixing container when the device is switched on and keep hair
and clothing away from it! Use the enclosed plunger to feed in ingredients.
❐ Always keep hold of the motor unit with one hand while preparing food.
❐ Always pull the mains plug out of the plug socket and allow the blades to come to a
complete standstill before you remove and / or replace the beaker or mixing container.
❐ The device may not be moved or transported while it is switched on.
❐ Do not use the device for longer than 1 minute without interruption. A cooling-down
period of 2 minutes must then be maintained.
❐ Never fi ll the device with boiling-hot food or liquids! The contents must not be hotter
than 50 °C.
❐ With solid foods, the maximum fi lling weight of the mixing container is 350 g.
❐ Do not overfi ll the mixing beakers or the mixing container. Only fi ll the large mixing
beaker and the mixing container up to the MAX mark. Only fi ll the small beaker up to
three quarters with food.
❐ Always keep the lid of the mixing container closed while preparing food. To add
ingredients, the insert in the middle of the lid can be removed.
❐ Do not force ingredients into the mixing container.
1. Always place the motor unit on a dry, even, and fi rm base. You may wish to place a
non-slip mat underneath the motor unit so that the surface is not damaged.
2. Decide whether you want to use a beaker or the mixing container (see the
"Accessories").
If you want to use a beaker:
– Pour the ingredients you want into the beaker of your choice.
– Depending on your requirements, screw the cross-blade or fl at-blade attachment
onto the beaker (see the "Accessories" chapter, "Cross-blade and fl at-blade
attachment" section).
If you want to use the mixing container:
– Unscrew the bottom cap of the mixing container and, depending on your
requirements, screw the cross-blade or fl at-blade attachment onto the mixing
container (see the "Accessories" chapter, "Cross-blade and fl at-blade attachment"
section).
– Turn the lid of the mixing container anticlockwise and remove the lid.
– Pour the ingredients you want into the container and then close the lid again. Make
sure that the lid sits on the container so that the pouring spout is completely closed
shut!
22