Publicité
Original instructions
General
1
Safety Instructions
• The assembly, commissioning, modifications and extensions may only
be completed by an experienced electrician!
• Before commencing work, remove the power supply from the device/
installations!
• During the operation of electrical components
– e. g. in the case of a short circuit hot and ionised gases can be
–
emitted
– protection covers must not to be removed!
• Pay attention to all local relevant electrical safety regulations!
• Disregard of the safety regulations can cause death, severe injuries or
extensive damage!
• Keep these operating instructions in a safe place for later use!
2
Common Applications
Safety switching device for sensors with 8,2 kOhm
LED
LCD display
"Mode" button
"Data" button
Terminals
Label (with terminal
description)
Before commencing the installation or assembly complete the following
safety precautions:
• Check the voltage data on the label of the switching device.
• Ensure that the device/installations can not be switched on!
• Determine that the power supply is disconnected!
• Separate or cover neighbouring components which are connected to
the power supply!
• Cover the device during assembly!
Foreign particles (e.g. borings from drilling) can damage the device.
• Protect the device with a housing against contamination or aggressive
environments!
Limited protection against accidental contact!
806SS-0060
ECN3F242
85
1
Publicité
