Using Your Outdoor Side Burner; Lighting The Side Burner - KitchenAid KBZU122T Instructions D'installation Et Guide D'utilisation Et D'entretien

USING YOUR OUTDOOR SIDE BURNER

WARNING
Burn Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Doing so can result in burns.
WARNING
Food Poisoning Hazard
Do not let food sit for more than one hour before or
after cooking.
Doing so can result in food poisoning or sickness.
1. Remove the outdoor side burner cover.
2. Make sure control knobs are turned to OFF.
3. Turn the gas supply on.
Natural gas or LP gas from a local supply
Using gas supply source other than 20 lb LP gas fuel tank:
Turn the shutoff valve to open position from the front of gas
supply line.
20 lb LP gas fuel tank, if converted
See the "Gas Supply Requirements" section.
Using a 20 lb LP gas fuel tank:
Slowly open the tank valve.
NOTE: If flow limiting device activates, your grill may not
light. If your grill does light, the flames will be low and will not
heat properly. Turn tank valve and all control knobs off and
wait 30 seconds. After shutting off the tank, very slowly open
tank valve and wait 5 seconds before lighting.
4. Do not lean over the side burner. Push in and turn the control
knob to LITE/HI and hold in.

Lighting the Side Burner

5. You will see the igniter glow. When burner is lit, release the
knob. Turn knob to desired setting.
6. Repeat for each of the other burners as needed.
IMPORTANT: If burner does not light immediately, turn the
burner knob to OFF and wait 5 minutes before relighting.
Manually lighting the side burner
1. Remove the outdoor side burner cover.
2. Remove the manual lighting extension (see following
illustration) and attach a match to the split ring.
3. Strike the match to light it.
4. Guide the match to the burner you wish to light.
5. Do not lean over the side burner. Push in and turn the burner
knob to LITE/HI for the burner closest to the lit match. The
burner will light immediately. When burner is lit, turn knob to
desired setting.
6. Repeat for each of the other burners as needed.
7. Remove match and replace manual lighting extension inside
its holder.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to manually light them,
contact the KitchenAid Customer eXperience Center. See the
"Assistance or Service" section.
13