Using Your Infrared Sear Burner; Outdoor Sear Burner Care; General Cleaning - KitchenAid KBEU121T Instructions D'installation Et Guide D'utilisation Et D'entretien

4. Do not lean over the sear burner. Push in and turn the sear
burner control knob to LITE/HI, while continuing to hold it in.
5. You will see the igniter glow. When burner is lit, release the
knob. Turn knob to desired setting.
IMPORTANT: If burner does not light immediately, turn the burner
knob to OFF and wait 5 minutes before relighting.
■ Preheat sear burner on high for 5 minutes. Preheating
provides the high heat needed to brown and seal the juices.
■
Shorten the preheat time when grilling high-fat cuts of meat or
poultry, such as chicken thighs. This will help reduce
flare-ups
Manually Lighting Infrared Sear Burners
1. Remove the outdoor sear burner cover.
2. Remove the manual lighting extension (see following
illustration) and attach a match to the split ring.
3. Strike the match to light it.
4. Guide the lit match between the grate and the burner cover.
5. Do not lean over the sear burner. Push in and turn the burner
knob to LITE/HI. The burner will light immediately. When
burner is lit, turn knob to desired setting.
6. Remove match and replace manual lighting extension inside
its holder.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to manually light them,
contact the KitchenAid Customer eXperience Center. See the
"Assistance or Service" section.
10

Using Your Infrared Sear Burner

Infrared grilling produces intense heat which quickly sears the
meat. Searing locks in flavor and juices while allowing the outer
surface to absorb smoke and food aroma that is produced as
grease and drippings are vaporized by the burner. The result is a
crisp, flavorful outside with a tender, juicy inside.
■ Preheat the infrared sear burner for 5 minutes.
■ Ensure that meats are fully thawed and that all excess fat is
trimmed away prior to grilling.
■
Leave the burner set to HI when placing food on the grill to
sear.
■ Use the sear burner to sear meat 1 to 2 minutes on each side,
then move the meat to the main grill cooking surface to finish
grilling to the desired doneness.
NOTE: View is shown with grate removed. Grate is
to be in place when using the infrared sear burner.
OUTDOOR SEAR BURNER
CARE

General Cleaning

IMPORTANT: Before cleaning, make sure all controls are off and
the sear burner is cool. Always follow label instructions on
cleaning products.
For routine cleaning, wash with soap and water using a soft cloth
or sponge. Rinse with clean water and dry at once with a soft,
lint-free cloth to avoid spots and streaks.
Do not use steel wool to clean the sear burner, as it will scratch
the surface.
Use stainless steel sear burner cover to protect finish from
weather.