Check And Adjust The Burners - KitchenAid KBZU122T Instructions D'installation Et Guide D'utilisation Et D'entretien

Plug in Side Burner
1. This built-in outdoor side burner comes with 5,000 mAmp
power transformer plug assembly for the igniter system. Plug
in the single-prong plug in the receptacle on the lower left-
hand side of the side burner.
A. Single-prong plug
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
2. Plug into a grounded 3 prong outlet.
3. Gently slide side burner completely into outdoor enclosure.
Assemble Cooking Area
1. Lift off cover and grate and set aside.
2. Remove packing from around burners.
3. Reinstall grate.
12
A
A
B
A. Cover
B. Grate

Check and Adjust the Burners

The burners are tested and factory-set for most efficient
operation. However, variations in gas supply and other conditions
may make minor adjustments to low flame setting necessary. It is
recommended that adjustments be made by a qualified person.
Checking and adjusting the burner flames requires removing the
grate.
Low flame adjustment:
If flame goes out on the LO setting, the low flame setting must be
adjusted.
1. Light the burner and turn control knob to its lowest setting
and remove knob.
2. Hold the valve stem with pliers and insert a thin flat blade
screwdriver into the shaft.
3. Watch the flame and slowly turn screwdriver
counterclockwise.
4. Adjust flame to the minimum stable flame.
A
A. Valve stem
B. Flat-blade screwdriver
C. Pliers
5. Replace control knob and turn off the burner.
6. Reassemble grate.
B
C