Publicité
SPECTRALIS 2
C'est le moment de commencer
3.0 "How to...?": C'est parti !
We wouldn't be at all surprised if this is actually the first chapter in this manual, which you
are reading. After all we're already on Page 24 of the manual and so far we haven't even
addressed getting your Spectralis to make noise! It'll get much more entertaining from here
on in!!
3.0.1 Préparations
You should make the following preparations, before you start working your way through
the "How to...?" part of the manual:
3.0.2 Etablir les connections audio
a.) Make sure that all your equipment (mixer, amplifier, active speakers, Spectralis etc.)
are turned off.
b.) Connect the sum-outs of the Spectralis with the input of the audio-system you are
using – whatever that may be.
c.) One by one turn on your other gear. Ideally start with the Spectralis.This eliminates
any chance that any sound from switching on power will reach your speakers. Turn the
mixer on next, then the amplifier and in case of self-powered speakers, turn them on last.
d.) Once everything is powered up, first lower the master-volume of the Spectralis.
e.) You can now use one of the numeric buttons, to start a pattern and can start raising the
volume – SLOWLY! Try to avoid running your system in the red all the time - even if you
like your music loud!You should set your input gain at level that will only occasionally
overdrive your LEDs rather than turning them into constant warning lights.
f.) Finally adjust the playback level on your amplifier. This should keep the distortion level
under control and you can work at your desired volume level.
3.0.3 Connecter un clavier MIDI
There are times when you will want to play your Spectralis via a keyboard for one of the
included "How to?"-chapters. Proceed as follows:
a.) Set your MIDI-keyboard up in close proximity to the Spectralis and connect it with a
power supply.
b.) Set the MIDI-channel of the keyboard to MIDI-Channel 1.
c.) Connect the MIDI-Out of your keyboard with the MIDI-In of the Spectralis using a MIDI-
cable.
d.) Once turned on the Spectralis can now receive the note-information sent by your
keyboard on MIDI-channel 1 and will assign the notes to the analog synthesizer section. In
case you are playing your keyboard right now, you should hear what you are playing.
Now that you're all set we're ready to GO !
24
Publicité
