Publicité
SPECTRALIS 2
In the upper row you will see the current information such as song-number (S01), current
song-name (Song01), the name of the selected pattern and the selected song-tempo in
BPM (beats per minute).
The lower row shows parameters, which can be changed with the encoders located below
the display. The significance of the various parameters is explained in the respective
chapters in this manual.
The type of entry will indicate the functionality of the encoders at the time:
For all display-entries where the description is followed by a colon and a parameter value
or a selection option turning the encoder will either prompt a selection list or change of
parameters.
For all entries which are shown in square parenthesis [ ] the encoder only has a push-
button function :
There are additional encoder functions in the menus for editing of sounds. Just push the
encoder button (OSCWAVE) in the oscillator-section right after turning on the Spectralis.
You will see the following display-message:
Here as well you will see a parameter description followed by a parameter-value, however
there is also an additional up-arrow right before the description. In this case you can turn
the encoder to change a parameter-value – the arrow however indicates, that the encoder
has also a button function – usually to call up a submenu connected to this parameter.
1/9:24dB Lowpass:Cutoff Modulation LFO
FMWve:0
FmRte:0
FMWve:0
FmRte:0
C:Funky
01/26 : VCO Shape
^Osc1:100 ^Osc2:100 ^Osc3:100 ^Osc4:100
FMDpt:0
FMDpt:0
[NO]
[YES]
23
Vue d'ensemble : affichage
Publicité
