Publicité
GB
• Avoid operating under difficult circumstances
(e. g.: extreme climate, use in freezing conditions,
or powerful magnetic fields).
• Do not take the vehicle jack apart. Taking it apart
will lead to subsequent faults and defects.
• Do not modify the setting of the adjusting screw
on the hydraulic cylinder (red cover cap)!
• Wash your hands after maintaining and/or using
the unit. There is a risk of poisoning!
• Always clean away any spilt hydraulic oil.
• Never exceed the maximum payload (► Techni-
cal data – p. 20).
• Only use the vehicle jack to lift vehicles according
their operating instructions. Ensure that the vehi-
cle lifting element is located firmly underneath the
vehicle. Improper use of the vehicle jack can lead
to serious material and health risks and will result
in the loss of the guarantee.
• Before lifting or lowering loads, ensure that their
are no people, animals or objects located under-
neath the unit or the load.
• Slowly and carefully open the lowering valve.
Quickly and suddenly opening the lowering valve
will result in the load dropping very quickly and
may cause an accident.
• Only use the supplied carry handle to carry the
unit.
• Never expose a loaded support frame to horizon-
tal forces.
• You must ensure that you are able to observe the
vehicle when lifting it, in order to prevent acci-
dents.
• In addition to these operating instructions, the
regulations of the vehicle manufacturer must be
observed.
• Symbols appearing on your product may not be
removed or covered. Information notices on the
product that are no longer legible must be
replaced immediately.
Read instructions for use before use.
Remaining risks
There will still be residual risks even when the device
is used according to the instructions and under obser-
vation of all of the safety notes in this set of operating
instructions:
• Risk of crushing in uncovered area.
Personal safety equipment
Wear safety shoes
Your device at a glance
Note: The actual appearance of your
device may differ from the illustrations.
Car jack
► P. 3, fig. 1
1. Rollers
2. Disc
18
3. Lifting arm
4. Carrying handle
5. Cover
6. Handle bar
Jack stands
► P. 3, fig. 2
7. Support
8. Frame
9. Securing pin
10. Bolt
What is included
• Car jack
• Jack stands (2×)
• Chocks (2×)
• Instructions for use
Installation
Car jack
– Bend the carrying handle (4) slightly outward and
lock it into place on the designated screw.
Jack stands
– Pull the securing pin (9) out.
– Remove the bolt (10).
– Insert shelf (7) into the frame (8) and set to the
required height.
– Insert the bolt (10) fully.
– Secure the bolt (9) using the securing pin (10) to
prevent it from pulling out.
Operation
WARNING! Risk to life! Keep children
and other unauthorised persons away
from the work area! Keep your hands and
feet away from any moving parts! Other-
wise, there is a risk of sustaining serious
injuries!
– Check the frame and lifting mechanism for dam-
age and deformation.
– Check if the lifting cylinder is tight and fully func-
tional.
– Make sure the surface under the car jack is level
and sufficiently strong.
Lifting loads
WARNING! Risk to life! The unit may
only be used on a solid, even surface with
a sufficient payload.
In the event of other surface types, there
is a risk of life-threatening injuries and of
the load tipping.
WARNING! Risk to life! Always secure
the load to prevent it from lowering!
Never work on an unsecured load! This
holds a risk of lowering and of life-threat-
ening injuries!
Publicité
