Publicité
• Drop material against infeed stop A and pivot into
cutter.
• Feed right to left, until reaching outfeed limit stop B.
• Pivot at outfeed stop.
• Switch off.
Mitre Fence - (Fig. 24)
• Isolate from power supply.
• Fit cutter.
• Adjust angle of mitre fence by loosening knob and
turning protractor head to line up angle required with
arrow.
• Place component onto mitre fence.
• Plug into power supply.
• Feed right to left holding component securely.
• Switch off.
NOTICE:
The mitre fence has fixing
holes to allow a spelch block to be secured using
screws (not supplied).
Lead-on Pin
- (Fig. 25a, 25b, 25c & 25d)
• Isolate from power supply.
• Fit lead-on pin into threaded hole using a slotted
screwdriver.
• Move back fence back.
• Fit self guided cutter.
• Fit top guard.
• Plug into power supply.
• Support component onto the lead-on pin and swing
into cutter and contact bearing guide.
• Mould component.
• Switch off.
WARNING:
Ensure guard is fitted when using self guided
cutters.
NOTICE:
The lead-in pin can be stored
in the pin park hole in the back fence when not in
use.
Edge Planing
- (Fig. 26a, 26b, 26c & 26d)
• The planing rods can be placed behind the left-hand
fence cheek to create either a 1.4mm or 2.4mm plane.
Guard removed for clarity.
EN - CRT/MK3
• The rods can be parked in the T-slots in the top of the
back fence.
• The rods are held by tightening the knobs.
• After use of the table, keep assembled and store
properly.
ACCESSORIES
Please use only Trend original spare parts and
accessories.
Hose and Connector Ref. CRT/4
- (Fig. 27a & 27b)
The back fence is provided with an extraction point for
connection to suitable vacuum extractors. The internal
hole diameter is 57mm (2-1/4").
• Only a vacuum extractor unit recommended for use in
the workshop should be used.
MAINTENANCE
The router table has been designed to operate over a
long period of time with a minimum of maintenance.
Continual satisfactory operation depends upon proper
tool care and regular cleaning.
• Replace the cutter insert when worn out.
Cleaning
• Keep the grooves clear of sawdust. Regularly clean the
table with a soft cloth.
• The pushstick is made of thermoplastic material which
is resistant to solvents, oils, greases and water. Do not
use concentrated acids or alkalies for cleaning.
Lubrication
• Your router table requires no additional lubrication. Do
not use PTFE spray on the plastic components of the
table.
Storage
• When not in use the table should be stored safely. It is
advisable to cover the table.
• The pushstick is provided with holes to store easily on
the table.
- 31 -
Publicité
