Publicité
Router Compatibility
TREND BASE
CONFIGURATION
Make
Router Model
TREND
T3, T4, T5
TREND
T8, T10, T11, T12, T14
CMT
CMT1E
DEWALT
DW613, 614, 615
DEWALT
DW624, 625E, DWE625,
627
ELU
MOF96)E) MK2
ELU
MOF131, 177 (E) MK2
PERLES
OF808(E) > 1999
Mounting Router to Insert Plate
- (Fig. 16)
OPERATION
No-Volt Release Switch - (Fig. 17)
• Plug machine into socket.
• Put plug of switch into mains supply.
• Switch on router.
• Press green button to switch on. To switch off press
red button.
WARNING:
when making any adjustments.
Cutter Guard & Feather Board
Adjustment - (Fig. 18a & 18b)
Back Fence Adjustment
- (Fig. 19a, 19b & 19c)
• Adjust back fence position by loosening the two knobs
(A) and pushing the fence forwards or backwards.
• Lock fence position by tightening the two knobs (A).
• Adjust fence cheeks based on size of router cutter by
loosening the four knobs on the back of the fence (B)
and sliding in and out.
Screw x Qty
B X 2
B X 3
B X 3
B X 2
B X 3
B X 2
B X 3
B X 2
Isolate from power supply
EN - CRT/MK3
Pushstick Operation - (Fig. 20)
The pushstick has been designed for use with a router
table, and should always be used when making any
cut less than 300mm in length or, when feeding the
last 300mm of a longer cut. The birds mouth is 90° and
should be angled at between 20° to 30° to the workpiece
to suit the height of the machinist.
CAUTION:
a lever or for uses other than those envisaged.
CAUTION:
requirements of the regulations in force is
nullified by any modification or tampering with the
pushstick.
Edge Moulding and Grooving
- (Fig. 21)
• Isolate from power source.
• Fit cutter.
• Set back fence position.
• Set top and side pressures.
• Fit guard.
• Check all knobs are tight.
• Plug into power supply.
• Switch on.
• Feed right to left.
• Switch off.
Feed Direction - (Fig. 22a, 22b & 22c)
• Always work with constant, medium rate. Feeding too
slow will results in burn marks and excessive heat build
up of the cutter.
• Good results will be obtained by removing small
amounts of material in several passes.
• Always feed work from right to left, following the arrow
on the router plate (in the opposite direction to the
rotation of the router cutter).
Stopped Moulding
- (Fig. 23a, 23b & 23c)
• Isolate from power supply.
• Fit cutter.
• Set back fence position.
• Fit some stops to back fence using cramps.
• Fit guard.
• Check all knobs are tight.
• Plug into power supply.
• Switch on.
- 30 -
Do not use the pushstick as
Compliance with the safety
Publicité
