Publicité
DESCRIPTION OF PARTS - (Fig. 1)
A. Legs
B. Insert Plate
C. Table Top
D. Back Fence
E. Fence Cheek
F. Top Feather Board
G. Cutter Guard
H. Lead-On Pin Hole
I. Mitre Fence
J. No-Volt Release Switch
K. Pushstick
L. Insert Rings
M. Table Top Scales
N. Side Feather Board
O. Dust Spout
P. Bench Mounting Bracket
Q. Lead-On Pin Storage
R. Spanner
S. Hex Key 3mm AF
T. Edge Planing Rod
U. Edge Planing Rod Locking Assembly
V. Backfence Scale
W. Cable Management Clips
X. Leg Rails Long
Y. Leg Rails Short
Z. Router Fixing Screw Pack
AA. Height Adjuster Storage Pin
ITEMS REQUIRED
• 2x Phillips® No.2. screwdriver for assembly.
• 1x Phillips® No.1. screwdriver for assembly.
• 10mm nut driver
ASSEMBLY
Assembly of Leg Frame
- (Fig. 2)
Bench Top Assembly - (Fig. 3)
Mounting Table to Workbench or
Workboard - (Fig. 4)
The router table can be mounted onto a suitable
workbench or workboard. Ensure the legs of the table are
supported and do not overhang.
A recommended working height is 900mm from table top
to floor.
EN - CRT/MK3
Mounting No Volt Release Switch
- (Fig. 5a & 5b)
The switch can be positioned at the front of the table or
on the right hand side.
Mounting T14 No Volt Release Switch
- (Fig. 6a & 6b)
The switch can be positioned at the front of the table or
on the right hand side.
CAUTION:
is comfortable and that the table is secured to
a work bench. Ensure workbench is stable and
secure.
Levelling the Insert Plate - (Fig. 7)
The insert plate can be levelled to the table top by
adjusting the seven set screws with the hex key.
Fitting Insert Rings - (Fig. 8a, 8b & 8c)
WARNING:
are a tight fit in the insert plate. Replace damaged
or loose rings immediately.
Back Fence Assembly - (Fig. 9a, 9b &
9c)
Fitting Back Fence - (Fig. 10)
Fitting Top Feather Board & Cutter
Guard
- (Fig. 11)
Fitting Side Feather Board
- (Fig. 12)
Fitting Mitre Fence - (Fig. 13)
Fitting Pushstick Storage - (Fig. 14)
Fitting Cable Management Clips
- (Fig. 15)
- 29 -
Ensure working position
Always ensure insert rings
Publicité
