Publicité
9
TROUBLESHOOTING
Problem
Possible cause
The handle is
The bolts are not
not in position.
engaged correct-
ly.
The machine
The battery ca-
does not start.
pacity is low.
The bail switch is
defective.
The safety key is
not put in.
The machine
The lawn is
cuts grass un-
rough.
evenly.
The blade height
is not set cor-
rectly.
The machine
Wet grass clip-
does not mulch
pings attach to
correctly.
the deck.
The mulch plug
is missing.
The machine is
The grass is too
hard to push.
tall, or the blade
height is too low.
The grass catch-
er and the blade
drags in thick
grass.
There is a high
The blade is un-
vibration in the
balanced and
machine.
worn.
The motor shaft
is bent.
The machine
The blade height
stops during
is too low.
mowing.
English
Problem
Solution
Adjust the height
of the handle
and make sure
that the knobs
and bolts are
aligned correctly.
Charge the bat-
tery pack.
Replace the bail
* If you cannot find the solution to these problems, go to
switch.
the service center.
Put in the safety
10
key.
Examine the
Voltage
mowing area.
Battery model
Adjust the blade/
cutting height to
Charger model
a higher position.
No load speed
Wait until the
Height adjust-
grass dries be-
ments
fore mowing.
Functions
Install the mulch
plug.
Double-insulated
construction
Increase the
blade/cutting
height.
11
Empty the grass
clippings from
the grass catch-
er.
Replace the
blade.
1. Stop the mo-
tor.
2. Remove the
Greenworks hereby warranties this product, to the
safety key
original purchaser with proof of purchase, for a period
and battery
of four (4) years against defects in materials, parts or
pack.
workmanship. Greenworks, at its own discretion will
3. Inspect for
repair or replace any and all parts found to be defective,
damage.
through normal use, free of charge to the customer.
4. Repair the
This warranty is valid only for units which have been
machine be-
used for personal use that have not been hired or
rented for industrial/commercial use, and that have
fore you start
been maintained in accordance with the instructions in
it again.
the operator manual supplied with the product from new.
Increase the
blade/cutting
height.
13
Possible cause
The battery pack
is out of power.
The grass clip-
pings attach to
the deck or the
blade.
Operation tem-
perature of the
machine is too
high.
TECHNICAL DATA
80 V DC
BAB703 and other BAB series
GCH8040 and other CAB series
2800 RPM
1 3/8 - 3 3/4" (3.5 - 9.5 cm)
Mulch & Rear Bag & Side discharge
LIMITED WARRANTY
GARANTIE OUTIL &
BATTERIE • GARANTÍA PARA
HERRAMIENTAS Y BATERÍAS
EN
Solution
Charge the bat-
tery pack.
Remove the bat-
tery pack and
check the deck.
Cool the ma-
chine.
Publicité
