Publicité
2. Motor stops while
mowing.
3. Mower runs but
cutting performance is
unsatisfactory, or does
not cut entire lawn.
4. Mower is too hard to
push.
5. Mower is abnormally
noisy and vibrates.
6. Battery charger LED's
not on.
7. Battery charger LED
does not flip to green.
8. Mower not picking up
clippings with the grass
collection bag.
9. When mulching there
are clippings visible.
10. Low or diminished
run-time after many
uses.
11. The battery charger
LED flashes red and the
battery can't be charged.
Type designation EJ740E EJ740E.X*** (7- designation
of machinery, representative of Cordless Lawn Mower)
Voltage........................40 V
No-load speed...................................2800 / 3000 / min
Deck diameter.....................................................43 cm
A. Release bail handle to turn mower off. Remove safety key, turn mower over and
check that blade is free to turn. If not free, return to an authorized servicer. Blade
should turn freely.
B. Raise cutting height of wheels to highest position and start mower.
C. Has battery been fully charged? Plug in charger and wait for green light to come
on.
D. Avoid overloading the mower. Slow down the cutting pace by pushing mower
slower or raise the cut height. Or both.
A. Has battery been fully charged? Plug in charger and wait for green light to
come on.
B. Release Bail handle to turn mower off. Remove safety key. Turn mower over
and check: Blade for sharpness - Keep blade sharp. Deck and discharge chute
for clogging.
C. Wheel height adjustment may be set too low for grass condition. Raise
cutting height.
A. Raise cutting height to reduce deck drag on grass. Check each wheel for free
rotation.
A. Release bail handle to turn mower off. Remove safety key. Turn mower on
side and check blade to ensure it has not been bent or damaged. If blade is
damaged, replace with a replacement blade. If the underside of the deck is
damaged return mower to an Authorized service center.
B. If there is no visible damage to the blade and the mower still vibrates:
Release bail handle to turn mower off, remove safety key and remove blade.
Rotate blade 180 degrees and retighten. If mower still vibrates, return the
mower to an authorized service center.
A. Check plug connection.
B. Replace charger.
A. Battery needs to be diagnosed. Take to authorized service center.
A. Remove mulch insert when bagging.
B. Chute clogged. Release Bail handle to turn mower off. Remove safety key.
Clear chute of grass clippings.
C. Too much cut grass. Raise cutting height of wheels to shorten length of the
cut.
D. Bag full. Empty bag more often.
A. Too much cut grass. Raise cutting height of wheels to shorten length of the
cut. Do not cut off more than 1/3 of total length.
B. Check blade for sharpness. Always keep blade sharp.
A. Return to Authorized Service location - may need new battery.
A. The battery overheats after continuous use. Remove battery from the charger
and allow it to cool to 42
TECHNICAL DATA
TECHNICAL DATA
Max.(2x20 V Max.)***
C or less.
o
Cutting diameter.................................................40 cm
Front wheel diameter.......................................180 mm
Rear wheel diameter........................................190 mm
Cutting height........................................20 mm-80 mm
Cutting height positions.............................................7
Grass collection capacity.......................................45 L
EN
15
Publicité
