Publicité
At least one battery is over
discharged (please refer to
Only one light is
the battery charge condition),
flashing twice per
please recharge the two
cycle.
batteries at once before use
again or storage.
Only one light is
At least one battery is hot,
flashing three times
wait for them cool down
per cycle.
before start again.
Only one light is
The machine is over load.
flashing four times
Raise the cutting height or
per cycle.
push slowly.
MOWING TIPS
NOTE: ALWAYS INSPECT AREA WHERE MOWER IS TO BE
USED AND REMOVE ALL STONES, STICKS, WIRE, METAL
AND OTHER DEBRIS WHICH MIGHT BE THROWN BY THE
ROTATING BLADE.
1. Mow across the face of slopes, never up-and-
down. Exercise extreme caution when changing
direction on slopes. Do not mow excessively
steep slopes. Always maintain good footing.
2. Release bail handle to turn mower "OFF" when
crossing any graveled area (stones can be
thrown by the blade).
3. Set mower at highest cutting height when
mowing in rough ground or in tall weeds.
Removing too much grass at one time can
cause circuit breaker to trip, which stops
mower.
4. If a grass bag is used during the fast growing
season, the grass may tend to clog up at the
discharge opening. Release bail handle to
turn mower "OFF" and remove the safety key.
Remove the grass bag and shake the grass
down to the back end of the bag. Also clean
WARNING: Stop the mower and remove the safety
key before removing the grass bag.
NOTE: To ensure long and reliable service, perform
the following maintenance procedures regularly.
Check for obvious defects such as a loose,
dislodged or a damaged blade, loose fittings,
and worn or damaged components. Check that
the covers and guards are all undamaged and
are correctly attached to mower. Carry out any
necessary maintenance or repairs before operating
mower. If the mower should happen to fail despite
regular maintenance, please call our customer
helpline for advice.
BLADE SHARPENING
KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE.
out any grass or debris which may be packed
around the discharge opening. Replace the
grass collection bag.
5. If mower should start to vibrate abnormally,
release bail handle to turn mower "OFF" and
remove safety key. Check immediately for
cause. Vibration is a warning of trouble. Do not
operate mower until a service check has been
made.
6. ALWAYS RELEASE BAIL HANDLE TO TURN
MOWER "OFF" AND REMOVE SAFETY KEY WHEN
LEAVING IT UNATTENDED EVEN FOR A SHORT
PERIOD OF TIME.
CUTTING AREA
The cutting area can be affected by several factors,
such as cutting height, lawn humidity, grass length
and density. Besides, starting and stopping the
mower too many times during operation will reduce
the cutting area.
TIPS:
1) It is recommended to mow your lawn more
frequently, walk at normal pace, and not to
start/stop the mower too often during operation.
Please always use the same two batteries and
charge the two batteries at same time.
2) For best performance, please ensure use 2 fully
charged battery pack and always cut off 1/3 or
less of the grass height.
3) Walk slowly when cutting long grass, so as
to have more effective cutting and properly
discharge the clippings.
4) Avoid cutting wet grass, otherwise it will stick
to the underside of the deck and the clippings
cannot be collected or discharged properly.
5) A higher cutting height shall be applied to new
or thick grass and it will extend the battery
duration.
MAINTENANCE
MAINTENANCE
WEAR PROPER EYE PROTECTION WHILE
REMOVING, SHARPENING, AND INSTALLING
BLADE. ENSURE THAT SAFETY KEY IS REMOVED.
Sharpening the blade twice during a mowing season
is usually sufficient under normal circumstances.
Sand causes the blade to dull quickly. If your lawn
has sandy soil, more frequent sharpening may be
required.
REPLACE BENT OR DAMAGED BLADE
IMMEDIATELY.
WHEN SHARPENING THE BLADE:
1. Make sure blade remains balanced.
2. Sharpen blade at the original cutting angle.
3. Sharpen cutting edges on both ends of blade,
removing equal amounts of material from both ends.
EN
13
Publicité
