Publicité
NOTE:
Be sure the mower is turned off and remove the key.
TO SHARPEN BLADE IN A VISE (SEE Fig. L1)
1. Be sure the bail handle is released, the blade
has stopped and the safety key removed before
removing the blade.
2. Remove blade from mower. See instructions for
removing and attaching blade.
3. Secure blade L1-1 in a vise L1-2.
4. Wear safety glasses and be careful not to cut
yourself.
5. Carefully file the cutting edges of the blade with a
fine tooth file L1-3 or sharpening stone.
6. Check balance of blade. See instructions for blade
balancing.
7. Replace blade on mower and tighten securely.
Refer to instructions below.
BLADE BALANCING (SEE Fig. L2)
Check balance of blade by placing center hole in
blade L2-1 over a nail or screwdriver shank L2-2,
clamped horizontally in a vise L2-3. If either end of
the blade rotates downward, file that end. Blade is
properly balanced when neither end drops.
BLADE MAINTENANCE (SEE FIG. M1, M2)
Renew your metal blade after 50 hours mowing
or 2 years, which ever is the sooner-regardless of
condition.
Follow these procedures to remove and replace the
blade. You will need garden gloves (not provided) and
a spanner wrench (not provided) to remove the blade.
Hold the blade and unscrew the blade bolt counter-
clockwise using a spanner wrench, and then remove
blade.
To re-assemble, position the blade with the cutting
Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling advice.
WARNING: SWITCH THE MACHINE OFF AND REMOVE THE BATTERIES PRIOR TO ANY TROUBLESHOOTING.
Problem
1. Mower doesn't run
when bail handle is
activated.
EN
14
ENVIRONMENTAL PROTECTION
ENVIRONMENTAL PROTECTION
TROUBLESHOOTING
TROUBLESHOOTING
A. Check to make sure safety key has been installed and is fully seated and that
button on switch housing is being completely pushed.
B. Release bail handle to turn mower off. Remove safety key, turn mower over
and check that blade is free to turn. If not free, return to an authorized servicer.
Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait for green light to
come on.
edges towards the ground. Then securely tighten the
blade bolt.
STORAGE (SEE Fig. K1, K2)
Stop the mower and always remove the safety key.
Clean the exterior of the machine thoroughly using
a soft brush and cloth. Do not use water, solvents
or polishes. Remove all grass and debris, especially
from the ventilation slots.
Turn the machine on its side and clean the blade
area. If grass cuttings are compacted in the blade
area, remove with a wooden or plastic implement.
Store the machine in a dry place. Do not place other
objects on top of the machine.
To aid storage, release the handle knobs, and fold the
handle as shown in Fig.K1, K2.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0 °C~45 °C.
The recommended ambient temperature range for
the charging system during charging is 0 °C~40 °C.
Details regarding safe disposal of used batteries
At the end of the life of the appliance, remove the
battery pack safely before disposing of the appliance.
Do not throw batteries away or throw them in the
normal trash can. Also do not dispose of the battery
with the machine. Remove the used battery pack
from the appliance and dispose of it at the nearest
or convenient dedicated recycling facility. If in
doubt, consult your local environmental protection
department. Batteries may enter water cycle if
disposed improperly, which can be hazardous for
ecosystem. Do not dispose of waste batteries as
unsorted municipal waste.
Solution
Publicité
