Publicité
Using a pencil, mark the four marks on the wall according to the dimensions shown in the diagram (see
Fig. 2).
Drill each mark to the diameter of the dowels, then insert the dowels (10) into the wall.
Fix the 4 sleeves (8) to the wall with the screws (9). Make sure that the opening on the side of the 2 upper
sleeves faces upwards. The opening on the side of the 2 lower sleeves should face downwards.
Screw the 4 brackets (tubes (5) and studs (4)) between the bars of the towel dryer as shown in Fig. 2,
using the screws (3).
Present the appliance to the wall brackets and insert the tubes (5) into the sleeves (8).
Press the unit against the wall, correct its verticality if necessary and screw the small locking screw (7)
into each sleeve (use the square washers under each locking screw). Make sure that the unit cannot be
removed from the sleeves.)
Finally, place the caps (2) on the studs (4).
Electrical connection
The appliance must be supplied via a residual current device (RCD) with a rated operating current not
exceeding 30mA.
The heater must be installed and connected to an installation in accordance with NF C 15-100 and by a
qualified electrician.
The connection to the mains is made via the power cable through a connection box.
Supply voltage: 230V ~ single phase - 50 Hz.
Raccordement électrique
Before any intervention, switch off the power supply from the main electrical panel. Connect the two
conductors of the power cable (Phase and Neutral) to a connection box. Make sure that the grey/blue
Tension d'alimentation : 230V ~ monophasé - 50 Hz.
wire is connected to the neutral and the brown/red wire to the phase. Check the tightness of the wires in
Le radiateur doit être installé et raccordé sur une installation en accord avec
the terminals of the wall connection box. The black wire called «pilot wire» must be connected to the pilot
la NF C 15-100 et par un électricien qualifié. L'appareil doit être raccordé dans
wire of the installation.
unboîtiermuralnormalisé placéà25cmaumoinsdusol.Laligneélectrique
de l'appareil doit être, selon la norme NFC 15-100, protégée par un dispositif
différentiel résiduel de courant assigné au plus, égal à 30mA, incorporé au
câblage del'installation.
Phase: brown / red
Phase : marron/rouge
Neutral: grey / blue
Neutre :gris/bleu
Pilot wire: black
Fil pilote : noir
Avant toute intervention, couper l'alimentation à partir du tableau électrique
général. Brancher les deux conducteurs du câble d'alimentation (Phase et
Fig.3
neutral
neutral
pilot wire
pilot wire
16
Mains power
supply
Publicité
