Publicité
GB
– Carefully align the sanding disc and press it firmly
onto the sanding plate.
Dust extraction
CAUTION! Health hazard due to dust!
Use a special extractor when extracting par-
ticularly harmful or dry dusts.
Note: The vacuum cleaner must be suitable
for the material to be processed.
► P. 3, fig. 2
– Operating with dust extraction: Affix the vacuum
adapter to the connecting piece (3). Connect the
vacuum unit to the adapter.
– Operating without dust extraction: Affix the vac-
uum adapter to the connecting piece (3). Push
the dust collector (5) onto the adapter.
Operation
Check before switching on!
Check the safe condition of the appliance:
– Check it for visual defects.
– Check that all parts of the machine have been
securely fitted.
– Make sure that the On/Off switch is not locked in
position.
Switching on/off
– Switching on: Set the On/Off switch (1) to posi-
tion [1].
– Switching off: Set the On/Off switch (1) to posi-
tion [0].
Electronic control of rotational speed
NOTICE! Risk of machine damage! The
motor can overheat when running at low
speeds under continuous heavy load. Cool
off the motor by running at high speed with-
out a load.
The appliance is equipped with an electronic rota-
tional speed control.
The rotational speed is infinitely adjustable (Rota-
tional speed range: ► Technical data – p. 27).
– Turning the speed regulator (2) clockwise
increases the rotational speed.
– Turning the speed regulator anticlockwise
decreases the rotational speed.
Grinding/sanding
DANGER! Risk of death through electric
shock! The machine must only be used for
dry sanding.
Fault/malfunction
Appliance is not running.
Sanding performance insufficient.
26
– Clamp in the workpiece or hold it firmly.
– Switch on the product and press it against the sur-
– Always use constant motion and only use light
Cleaning
Overview of cleaning
Regularly, depending on conditions of use
What?
Remove all dust from the
ventilation slits of the mo-
tor.
Clean the machine.
Empty the dust container
► P. 3, fig. 2
– Pull the dust collector (5) fully away from the rear
► P. 4, fig. 3
– Press the unlock push butons (6) and keep them
– Remove the lid (7) from the dust collector.
► P. 4, fig. 4
– Remove the filter mat (8).
– Empty the dust container.
– Re-install the dust container in reverse order. Pay
Malfunctions and troubleshooting
In the event of a malfunction...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Cause
Appliance is faulty?
Sanding sheet unsuitable for the
material?
Sanding sheet worn?
Note: When working vertical surfaces, hold
the device in such a manner that the dust
sack faces downward.
Note: Excess pressure does not result in
improved sanding performance, but
increases the wear on the appliance and the
sanding sheet.
face to be sanded applying even pressure.
pressure.
Note: Always empty the dust collector to
ensure optimum dust collection.
of the device.
pressed.
attention to the correct position of the filter mat.
DANGER! Risk of injury! Improperly con-
ducted repairs may prevent your machine
from working safely. Such repairs will
endanger you and your surroundings.
Remedy
Contact your local vendor.
Replace the sanding sheet (► Fit-
ting the sanding sheet – p. 25).
How?
Use a vacuum cleaner or
a brush.
Wipe the unit with a
slightly damp cloth
Publicité
