Publicité
Push the buttons on the carrycot supports and align them parallel to the ground
so that they do not interfere with putting the carrycot down (fig. 26).
Baby seat installation and removal (applies to 3-in-1 set)
•
The connectors are compatible with these products: Lionelo (Astrid, Mari
Carrier, Greet Carrier). Insert the adapters into the appropriate places on the
stroller frame until you hear a click on both sides and the adapters are locked.
•
The seat in the stroller frame should be installed so that the child in it is
positioned facing the person driving the stroller.
•
Place the baby seat on the frame of the stroller using the adapters (fig. 27).
You will hear a distinctive click. Make sure the seat is properly installed on
the frame of the stroller.
•
To unbuckle the seat as needed, remove the seat from the adapters.
•
To remove the adapter, press the bottom button on it (A, fig. 27) and remove.
Cleaning and maintenance
•
The wheels and frame of the stroller should be regularly cleaned of dust and
sand. These parts can be cleaned with a damp cloth and mild cleaning agents.
•
The various parts of the stroller and carrycot should be regularly inspected
for functionality, durability, and possible damage. If defects are detected,
contact an authorized service center.
•
Use only spare parts recommended by the manufacturer.
•
Do not use strong chemical agents to clean this product. In the event of dirt,
wipe the material with a damp cloth.
Photos are for reference only, the actual appearance of the products may differ from that
shown in the photos.
‑ 19 ‑
EN
Publicité
