Publicité
stroller suspension functions properly.
1 – hard suspension
Folding the stroller
Fold down the seat canopy, facing forward, slide the folding lever on either side of
the handle and then push the frame down until the stroller folds down. The lock
will latch automatically (fig. 19).
The stroller cannot be folded with the carrycot installed.
Carrycot
A.
Carrycot installation on the frame of the stroller.
1.
Extend the supports into their intended place on the bottom of the carrycot (fig. 20).
2.
Press the buttons on the carrycot connectors, then position them facing
the ground (fig. 21).
3.
Lift the canopy of the carrycot and put the mattress in it.
4.
Place the carrycot on the frame of the stroller (fig. 22), correct installation
will signal a characteristic audible "click".
5.
Connect the locking device, located under the bottom of the carrycot with
the frame of the stroller to improve the stability of the carrycot (fig. 23).
Make sure the carrycot is properly installed and cannot be freely removed from
the stroller frame.
Caution. The carrycot should be installed facing the person driving the stroller
so that the caretaker has eye contact with the child.
B.
Folding down the carrycot canopy
To fold the carrycot canopy, press both adjustment buttons at the same time,
then push the canopy down in the direction (fig. 24).
C.
Carrycot removal
The baby can be carried in the carrycot.
To remove the carrycot, first release its locking mechanism from the frame of the
stroller (fig. 23), then press the two support release buttons in sequence until you
hear a "click" (you do not need to keep these buttons pressed) and lift it (fig. 25).
EN
2 – medium suspension
hardness
‑ 18 ‑
3 – soft suspension
Publicité
