Publicité
GB
– Insert the battery pack into the charger.
– Plug the charger into the power supply.
The charging status is displayed by the con-
trol lights (18).
– Slot the battery pack into the device and
make sure it clicks into place correctly.
Checking the remaining capacity of the
battery
– Press the button (16).
The remaining capacity of the battery is dis-
played by the control lights (15).
Check before starting!
DANGER! Risk of injury! The
device must only be put into operation
if no faults are found. If any part of the
device is defective, it must be
replaced before the next use.
Check the safety equipment and the safe
condition of the device.
– Check all parts for their firm fit.
– Check whether there is any leakage.
– Check whether there are visible defects:
broken parts, cracks, etc.
– Check the device for correct chain ten-
sioning.
– Check the function of the chain brake.
Switching on/off
► P. 5, fig. 9
– Hold the device fast with both hands.
– The hand guard (3) must be folded
towards the back.
– Switching on: Press switch-on safety
lock (10) and On/Off switch (11) simulta-
neously.
– Switching off: Release On-Off switch (11).
Use
Before use, familiarize yourself sufficiently
with the sawing technique for chain saws.
You will find information about this in the trade
literature. We recommend that you attend
suitable training sessions. The notes here
serve only as a complement!
60
Correct posture
DANGER! Risk of injury! Never
work on unstable subsurfaces!
Never work above shoulder height!
Never work while standing on a lad-
der!
Do not work bent too far forward!
Only use the device under favourable
weather and site conditions!
– Stand with both legs securely on the
ground.
– Heed obstacles in the work area.
– While you are working, always hold the
device fast with both hands!
Hold the device:
– with the left hand on the front handle.
– with the right hand on the rear handle.
– balanced in a secure position.
Here's how to saw correctly!
DANGER! Risk of injury! Always
switch the motor off before you put
the device down!
• Search the work area and remove objects
which are in your way.
• When you begin work, check the safety of
the device (► Check before starting! –
p. 60).
• Take the device in both hands as
instructed.
Risk of kickback!
Kickbacks occur if the upper edge or tip of the
saw bar touch wood or other hard objects.
The device is thrown with high energy back
and forth, which can cause extremely severe
injuries.
DANGER! Risk of injury! When
working with the device, dangerous
kickbacks may occur! Severe or even
fatal injuries can be the result! Before
beginning work with the device, the
chain brake must be checked to
ensure that it is functioning correctly.
Avoid letting the area of the saw bar depicted
on the right touch wood or other hard objects.
Publicité
