Publicité
– Attach tank cover and close flap.
– If you have spilled any saw chain oil, be
sure to wipe it up.
Operation
Safety equipment
The device has several pieces of safety
equipment which reduce the risk of injury
when working:
Claw stop
The claw stop enables the motor block to be
secured to the wood when using pull saws.
Uncontrolled kickback of the saw is thus
made more difficult. The process also exerts
pressure on the saw chain thanks to the gen-
erated leverage.
Chain catcher
The chain catcher serves to catch a torn saw
chain or one which has jumped out of the
guide. Through regular maintenance of the
saw bar and correct and regular tensioning of
the saw chain, accidents of this type can be
prevented.
Rear hand guard
The rear hand guard serves to protect the
hand against a jumped chain and disturbing
branches and twigs.
Charging the battery pack
WARNING! Risk of injury! Comply
with all safety instructions when han-
dling rechargeable devices.
NOTICE! Risk of damage to the
unit! Due to the high operating cur-
rent, the unit must only be operated
with batteries with a capacity of at
least 4 Ah (article number 196052).
Replacement batteries with article
number 196051 are not suitable for
operation with this unit.
NOTICE! Risk of damage to the
unit! Do not allow the battery pack to
deep discharge.
NOTICE! Risk of damage to the
unit! Do not press the On/Off switch
after the device has deactivated auto-
matically.
Note: The Li-Ion battery pack can be
charged at any time without affecting
the lifetime of the unit. Interrupting the
charging process will not damage the
battery pack.
Note: If the battery is fully loaded, the
charger automatically switches over
to the maintenance charge function.
The battery can thus remain in the
charger permanently.
The battery pack must be charged prior to the
first start-up (charging time: ► Technical
data – p. 64).
► P. 5, fig. 7
– Press in the locking button (17) and
remove the battery from the device.
► P. 5, fig. 8
GB
59
Publicité
