Publicité
GB
• Instructions for use
Assembly
DANGER! Risk of injury during
operation! Improperly mounted parts
can cause severe and even fatal inju-
ries when using the device! This
device may only be commissioned if
all parts are mounted completely and
tightly and no part is damaged!
• Therefore, read the whole chapter
before you assemble the parts!
• Assemble the parts carefully and
completely.
• Use tools when their use is sug-
gested.
CAUTION! Risk of injuries due to
cuts! The teeth of the saw chain are
very sharp! Protective gloves must be
worn for all work on the chain.
WARNING! Risk of injury! An
improperly mounted saw chain
causes uncontrolled cutting behav-
iour of the device! When assembling
the chain, heed the prescribed run-
ning direction!
Assembling the saw bar and saw chain
► P. 4, fig. 4
– Loosen the nut (6) on the chain wheel
guard (7) and remove chain wheel guard.
► P. 4, fig. 5
– Place Saw bar (5) on the guide rail (21)
with the guide groove (20).
Note: When attaching the chain,
heed the correct position of the guide
groove (saw bar).
– Place the saw chain (4) around the chain
wheel (22). Heed the assembly direction.
– Place the saw chain (4) around the saw
bar (5).
► P. 4, fig. 6
– Attach the chain wheel guard (7).
– Tighten the fastening nut (6).
Tensioning the saw chain
► P. 4, fig. 6
– Tighten the fastening nut (6) until the
chain lies on the underside of the saw bar.
58
Letting the saw chain run in
During the run-in time, re-tension the saw
chain and rail after a maximum of 5 cuts.
Checking the tensioning of the saw
chain
The saw chain is tensioned correctly if it lies
close against the underside of the saw bar
and can be moved easily by hand.
Readjust tension of the saw chain when nec-
essary (► Re-tensioning the saw chain –
p. 63).
Checking the chain lubrication
The device may not be used without sufficient
chain lubrication. Insufficient lubrication
reduces the service life of the device.
– Check the oil quantity in the tank.
– Start the device.
– Hold the running saw chain approx. 15 cm
over a suitable surface for a time (15 s).
If there is sufficient chain lubrication, the oil
spraying off of the saw chain will form a slight
trail.
Checking the chain brake
The chain brake ensures immediate blocking
of the saw chain in case of a kickback. Before
beginning work with the device, it must be
checked to ensure that it is functioning cor-
rectly.
– Set device on the ground.
– Start the device.
– Tip the hand guard forwards. The chain
must stop immediately.
– If the chain brake is not working correctly,
contact a service partner immediately.
Filling up saw chain oil
NOTICE! Environmental damage!
Since the saw chain oil can penetrate
the environment during operation,
biologically-degradable special vege-
table-based saw chain oils should be
used.
► P. 4, fig. 6
– Lay device securely with the tank
cover (2) upwards.
– Before opening, clean the tank cover and
the filler neck if necessary.
– Open flap and remove tank cover.
– Carefully fill up the saw chain oil. Do not
spill!
– Read the oil level at the inspection
glass (8). The oil stand must be placed
between [MIN] and [MAX].
Publicité
