Publicité
GB
Material/surface
Pre-sanding of rough-sawn or
non-planed wood, e.g. beams and
boards
Even sanding of wooden surfaces
Elimination of unevenness
Fine sanding of wooden surfaces
Finishing sanding of hardwood
Sanding to remove paint
Sanding metal to remove rust
Shape plastics and putty mass
Lightly sanding primer
Sanding metal
Smoothing plastic surfaces
Finely sanding metal, plastics and
primers before painting/varnish-
ing
Fitting the sanding sheet
Note: Both perforated and unperforated
sanding sheets can be used. Dimensions:
► Technical data – p. 31
Note: Position perforated sanding sheets so
that the holes in the sanding plate and the
sanding sheet coincide.
The fixture of the sanding disc takes place by means
of hook and loop adhesion.
– Carefully align the sanding disc and press it firmly
onto the sanding plate.
Dust extraction
CAUTION! Health hazard due to dust!
Use a special extractor when extracting par-
ticularly harmful or dry dusts.
Note: The vacuum cleaner must be suitable
for the material to be processed.
► P. 4, fig. 5
– Operating with dust extraction: Connect the suc-
tion tube of the vacuum cleaner to the suction
nozzle (11).
– Operation without dust extraction: Push the dust
collector (3) onto the nozzle (11).
Operation
Check before switching on!
Check the safe condition of the appliance:
– Check it for visual defects.
– Check that all parts of the machine have been
securely fitted.
– Make sure that the On/Off switch is not locked in
position.
Switching on/off
– Switching on: Set the On/Off switch (1) to posi-
tion [1].
– Switching off: Set the On/Off switch (1) to posi-
tion [0].
30
Granularity
coarse: 40–80
medium: 80–120
fine: 150–240
coarse: 40–80
medium: 80–120
fine: 150–320
Electronic control of rotational speed
NOTICE! Risk of machine damage! The
motor can overheat when running at low
speeds under continuous heavy load. Cool
off the motor by running at high speed with-
out a load.
The appliance is equipped with an electronic rota-
tional speed control.
The rotational speed is infinitely adjustable (Rota-
tional speed range: ► Technical data – p. 31).
– Turning the speed regulator (4) clockwise
increases the rotational speed.
– Turning the speed regulator anticlockwise
decreases the rotational speed.
Grinding/sanding
DANGER! Risk of death through electric
shock! The machine must only be used for
dry sanding.
Note: When working vertical surfaces, hold
the device in such a manner that the dust
sack faces downward.
Note: Excess pressure does not result in
improved sanding performance, but
increases the wear on the appliance and the
sanding sheet.
– Clamp in the workpiece or hold it firmly.
– Switch on the product and press it against the sur-
face to be sanded applying even pressure.
– Always use constant motion and only use light
pressure.
Cleaning
Overview of cleaning
Regularly, depending on conditions of use
What?
Remove all dust from the
ventilation slits of the mo-
tor.
Clean the machine.
Malfunctions and troubleshooting
In the event of a malfunction...
DANGER! Risk of injury! Improperly con-
ducted repairs may prevent your machine
from working safely. Such repairs will
endanger you and your surroundings.
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
How?
Use a vacuum cleaner or
a brush.
Wipe the unit with a
slightly damp cloth
Publicité
