Publicité
Risks caused by vibrations
CAUTION! Risk of injury due to vibra-
tions! Vibrations may, in particular for per-
sons with circulation problems, cause dam-
age to blood vessels and/or nerves.
If you notice any of the following symptoms,
stop working immediately and consult a doc-
tor. Numbness of body parts, loss of sense
of feeling, itching, pins and needles, pain,
changes in skin colour.
The vibration values specified in the technical data
represent the main uses of the device. The actual
existing vibrations during use may deviate from these
as a result of the following factors:
• Incorrect use of the product;
• Unsuitable tools inserted;
• Unsuitable material;
• Insufficient maintenance.
You can reduce the risks considerably by following
the tips below:
– Maintain the device in accordance with the
instructions in the operating instructions.
– Avoid working at low temperatures.
– When it is cold, make sure your body and your
hands, in particular, are kept warm.
– Take regular breaks and move your hands at the
same time to promote circulation.
• Symbols appearing on your product may not be
removed or covered. Information on the product
that are no longer legible must be replaced imme-
diately.
Read and observe the operating instruc-
tions before commissioning.
Only re-charge the battery pack indoors.
Do not dispose of a battery pack with the
household waste!
Do not dispose of a battery pack in water!
Do not burn the battery pack!
Do not expose the battery pack to sunlight
or increased temperatures!
MAX xx °C
MAX xx °C
Personal safety equipment
Wear a dust protection mask when the
work develops a lot of dust.
Wear protective glasses when using abrad-
ing equipment.
Wear ear defenders when working with the
device.
Your machine at a glance
Note: The actual appearance of your prod-
uct may differ from the illustrations.
► P. 3, fig. 1
1. On-Off switch
2. Battery pack (not included in the scope of deliv-
ery)
3. Dust container
4. Rotational speed controller
5. Sanding plate
► P. 3, fig. 1
6. Display for remaining capacity
7. Push button for capacity display
8. Locking button
9. Control lights
10. Battery charger (not included in the scope of
delivery)
Scope of supply
• Cordless orbital sander
• Dust container
• Sanding discs (3×)
• Instructions for use
Commissioning
Charging the battery pack
Note: Rechargeable battery and charger
are not part of the scope of delivery and are
available optionally from your dealer
(► Accessories – p. 31).
WARNING! Risk of injury! Comply with all
safety instructions when handling recharge-
able devices.
NOTICE! Risk of damage to the unit! Do
not allow the battery pack to deep dis-
charge.
Note: If the battery is fully loaded, the
charger automatically switches over to the
maintenance charge function. The battery
can thus remain in the charger permanently.
The battery pack must be charged prior to the first
start-up (charging time: ► Technical data – p. 31).
► P. 4, fig. 3
– Press in the locking button (8) and remove the
battery from the device.
► P. 4, fig. 4
– Insert the battery pack into the charger.
– Plug the charger into the power supply.
The charging status is displayed by the control
lights (9).
– Slot the battery pack into the device and make
sure it clicks into place correctly.
Checking the remaining capacity of the battery
– Press the button (7).
The remaining capacity of the battery is displayed by
the control lights (6).
Selection of sandpaper
Sandpaper with various granulations is used in
accordance with the material to be processed and the
intended sanding results:
GB
29
Publicité
