Publicité
Device-specific safety instructions
• The product must be standing on an even, hori-
zontal surface with clearance to all sides.
• The product may not be operated outdoors.
• Never put objects through the protective grille into
the product.
• Objects that can be pulled (e. g. curtains, plants),
must not be in the immediate vicinity.
• Never expose the product to water or other liq-
uids.
• The product must not be operated in rooms with
bathtubs, showers or swimming pools or near to
wash basins or water connections.
• Remember that moving parts may also be located
behind ventilation and venting slots.
• Symbols appearing on your device may not be
removed or covered. Signs on the device that are
no longer legible must be replaced immediately.
Read and observe the instructions for use
before using the product for the first time.
Your appliance at a glance
Note: The actual appearance of your prod-
uct may differ from the illustrations.
► Overview – p. 3
1. Switching knob
2. Timer knob
3. Control panel
4. Fan body
5. Front base
6. Rear base
7. Power cord
Scope of delivery
• tower fan
• base (consisting of 2 parts)
• set of operating instructions
• screw
Unpacking
– Remove all parts from the packaging.
– Check all parts are present and no defect before
assembly.
Setting up
► Assembly – p. 9
– Pass the power cord (7) through the central gate
and firmly clamp the front base (5) with the rear
base (6), then adjust the position of fan body with
that position of the base, and fix the screws of the
base with a screwdriver
Fault/malfunction
Product not running.
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
– Pass the power cord through the gap of the base.
Operation
► Operation – p. 10
– Insert the mains plug into a mains socket corre-
120 minutes timer
► P. 10, fig. 3
• [ON]: timer on
• [OFF]: timer off
• [30-60-90-120]: minutes
► P. 10, fig. 4
• [OFF]: to turn off the fan
• Speed selection: turn on the fan by selecting the
• Oscillation [
Storage and transport
Storing
– Store the device and any accessories in a dry,
– In case of longer periods without operation, pro-
Transport
– Use the original packaging to ship whenever pos-
Cleaning
– Turn off the product, pull out the mains plug.
– Clean the fan with a soft damp cloth. Do not
Troubleshooting
If something stops working...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Cause
No mains voltage?
Cable faulty?
sponding to the technical data.
speed: [1] – Low, [2] – Med., [3] – High
]: The speed with [
means there is oscillation.
well-ventilated place.
tect the device and its accessories against soiling
and corrosion.
sible.
DANGER! Caution, risk of injury! Alway
disconnect to the supply main before main-
tenance.
immersed the fan in water.
DANGER! Risk of injury! Improper repairs
can result in the product functioning
unsafely. This endangers yourself and your
environment.
Remedy
Check cable, plug, socket and fuse.
Contact your local vendor.
GB
]
21
Publicité
