Publicité
GB
• The distance towards the front between the venti-
lation grate and objects must be at least 100 cm.
• The air supply of the product situated at the
underside may not be covered e. g. by shag-piles.
Make sure that no foreign body or dust can be
sucked.
• The product may not be operated outdoors.
• The device may never be operated without super-
vision.
• If the device is left unattended or is not used for
longer period, remove the plug from the socket
allow the product to cool down and store it in a
safe.
• The device may not be covered. There is danger
of fire.
• Never put objects through the ventilation grate
into the device, danger to life!
• Never put the device in water or other liquids.
• When operating the produce, heed sufficient
safety distance. It must be ensured the people
who are in the bathtub or shower cannot reach the
device.
• Do not use adapters or extension cords.
• Do not use the heater in conjunction with a timer
or any other switch capable of automatic activa-
tion, as this creates a fire hazard.
• This appliance can be used by children aged from
8 years and above and by persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and if they understand
the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
• Children of less than 3 years should be kept away
unless continuously supervised.
• Children aged from 3 years and less than 8 years
shall only switch on/off the appliance provided
that it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
• CAUTION! Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and vul-
nerable people are present.
• The most common cause of overheating is depos-
its of dust or fluff in the appliance. Ensure these
deposits are removed regularly by unplugging the
appliance and vacuum cleaning air vents and
grilles.
• This appliance heats up slightly when in use. To
avoid burns, do not let bare skin touch hot sur-
faces.
• Symbols appearing on your device may not be
removed or covered. Signs on the device that are
no longer legible must be replaced immediately.
Read and observe the instructions for use
before using the product for the first time.
22
To prevent overheating, do not cover the
heater!
Assembly
Safety distances
► P. 3, fig. 1
DANGER! Danger of electric shock! The
product is suitable for operation in Zone 3.
DANGER! Danger of electric shock!
Before drilling the holds, make sure that
there are no electrical or other lines in the
wall.
DANGER! Risk of injury! The device may
not be mounted directly below a wall outlet.
Danger of cable fires!
• Distance between the equipment and the ceiling
is at least 200 mm. Distance on both sides of the
wall is at least 250 mm. Distance between the out-
let and the bottom is from 150 mm to 180 mm.
When the towel rack is mounted on the wall, a
minimum distance of 600 mm to the ground are
met.
• When the device is mounted in the bath, it should
be placed in dry place such as installed on walls
in front or behind toilet or beside the door.
Mounting And Electrical Connection
Note: when mounting the appliance, there
must be enough space for the appliance
► P. 3, fig. 2
– Drill three holes on the wall (position A, B, C), be
sure to make the diameter as same as the
expanding bolt, insert plastic expanded anchors
into all these three holes.
– fix two screws into the anchors (position A & B),
and leave 10 mm of the screw out. Hang up the
appliance.
– fix the bottom screw on the anchors (position C).
1. screw fixed
2. important: this screw must be fixed strong
Operation
Check before switching on!
DANGER! Danger to Life! The product
may only be put into operation if no defects
or faults are found during the check-up.
Ensure that any defective parts are replaced
before the product is used again.
Check the safe condition of the product:
– Check whether there are any visible defects.
– Check whether all parts of the product are firmly
attached.
Control Panel View:
Note: The actual appearance of your prod-
uct may differ from the illustrations.
► P. 4, fig. 1
1. Power indicator
Publicité
