Publicité
– Slacken the coupling nut (12).
– Pull the telescopic pole (20) to the desired length.
– Retighten the coupling nut (12) again.
Setting the angle of the cutting head
► P. 4, fig. 3
– Press in and hold the locking button (11).
– Tilt the cutting head (10) to the required position.
– Release the locking button (11) again.
Switching on and off
– Switching on: Press the switch lock (2) and simul-
taneously press the On/Off switch (1).
– Switching off: Release the on-off switch (1).
Cleaning and maintenance
DANGER! Risk of injury! Remove the bat-
tery pack before conducting any work on the
device.
Cleaning and maintenance overview
Note: Clean unit immediately after every
use. Dried grass remains are very hard, and
are very difficult to remove.
If necessary
What?
Cleaning the device
Replacing the cutting insert
► P. 5, fig. 8
– Slide the cutting insert (9) inward and push it out
of the pin (21) on the cutting disk (7).
– Place the new cutting insert (9) on the pin (21)
and pull out the insert until it snaps in.
Storage, transportation
Storage
– Store the tool in a dry and well ventilated place.
Transportation
– When dispatching, try to use the original packag-
ing, if possible.
Error/Fault
Device does not work.
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
How?
Wipe the unit with a damp
cloth.
Cause
Battery not slotted in correctly?
Battery pack discharged?
Battery pack defective?
Is the device defective?
Storing rechargeable batteries
Note: Rechargeable batteries last the long-
est when they are well cared for and, above
all, stored at the correct temperatures. How-
ever, with increasing age, the capacity
decreases even when stored correctly. A
significantly reduced operating time despite
a full battery indicates that it has been used
up.
• Leaving the battery in an empty state for a long
time may damage it and greatly reduce its capac-
ity.
• Charge batteries before storage to avoid damage
and deep discharges. The optimum charge level
before storage is around 70%.
• If stored for a very long time, check the charge
level regularly; recharge the battery if necessary.
• Store batteries in dry and well-ventilated rooms.
• Protect batteries from moisture and water.
• If possible, store batteries in the following loca-
tions:
– in rooms with smoke detectors;
– not near flammable or combustible objects;
– not near sources of heat;
• The optimum storage temperature is 10–20 °C.
• Batteries must not be stored below 0 °C or above
40 °C as extreme temperatures may cause the
batteries to become damaged.
• Do not expose batteries to direct sunlight.
• Disconnect batteries from the device before stor-
age.
• Do not leave batteries permanently connected to
the charger.
Troubleshooting
DANGER! Risk of injury! Unprofessional
repairs may mean that your unit will no
longer operate safely. This endangers you
and your environment.
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Remedy
Slot battery into place.
► Charging the battery pack –
p. 26.
Contact your local vendor.
Disposal
Disposal of the appliance
A crossed-out wheelie bin icon means: Bat-
teries and rechargeable batteries, electrical
or electronic devices must not be disposed of
with household waste. They may contain
substances that are harmful to the environ-
ment and human health.
GB
27
Publicité
