Sinmag Europe SE7L Mode D'emploi page 4

ENG
Main parts of mixer:
1. Label
2. Stirring shaft
3. Stainless steel bowl
4. Base
5. Connecting Knob
6. Speed control switch
7. on/off knob
8. Power cord
Operation:
1.
mixer uses is 240 volt 50Hz. (please use electric outlet with 3 wide contacts and
good grounding)
2.
head and fix it. Place stirrer on stirring shaft and turn it 45° counter clockwise.
3.
and turn bowl to fix it.
4.
the head and tighten connection knob 5, turn speed control switch to lowest
speed, turn power switch 7 on and then set required speed gradually after stirrer
is in normal operation.
5.
lowest speed firstly, then turn power switch off and unplug.
4
The standard value of operating alternating current which the
Installation of stirrer: loosen connecting knob 5 of head; raise
Installation of stainless bowl. Place stainless bowl on bowl seat
Procedure of starting mixer: After materials are filled in; lower
When operation is completed, turn speed control switch to the
SINMAG EUROPE BVBA