7.3 Pump Filter
1
3
5
The pump filter system in your Washing
Machine prolongs the life of the pump
by preventing lint from entering your
machine.
We recommend that you clean the
pump filter every 2 months.
The pump filter is located behind the
cover on the front-lower right corner.
To clean the pump filter:
1. You may use the washing powder
spade (*) supplied with your machine
or liquid detergent level plate to open
the pump cover (**).
2. Lodge the end of the powder spade or
liquid detergent level plate in the
opening of the cover and gently press
backwards. The cover will open.
•
Before opening the filter cover, place
a container under the filter cover to
collect any water left in the machine.
Loosen the filter by turning anticlock-
•
wise and remove by pulling. Wait for the
water to drain.
NOTE:
amount of water inside the machine, you
may have to empty the water collection
container a few times.
3. Remove any foreign materials from
the filter with a soft brush.
4. After cleaning, re-fit the filter by
inserting it and turning clockwise.
5. When closing the pump cover, ensure
that the mountings inside the cover
2
4
6
Depending on the
meet the holes on the front panel side.
6.
Close the filter cover.
WARNING:
the pump may be hot, wait until it has
in
cooled down before carrying out any
cleaning or maintenance.
(*) Specifications may vary depending on
the machine purchased.
(**)Instead of pump cover part, Plinth
sheet part is using in Built-in Machine. To
remove the plinth sheet part, please
follow the Built-in Installation Manual
instructions.
7.4 Detergent Drawer
The use of detergent may cause residual
build up in the detergent drawer over
time. We recommend that you remove
the drawer every 2 months to clean the
accumulated residue.
To remove the detergent drawer:
•
Pull the drawer forwards until it is fully
extended.
Press the region shown below inside
•
the detergent drawer you have pulled
all the way back, and continue pulling
and remove the detergent drawer from
its place
25
The water
V.1