Publicité
Beware of static
In order to protect the semiconductor components and PCB from the
static damage, please wear anti static device or touch the metal part of
the enclosure to remove static in advance before contacting the
conductors and PCB of the machine internal wiring.
Keep it dry
Avoid rain, water and vapor infiltrating the machine. If there is, dry it
and check the insulation of the cutting machine (including that
between the connections and that between the connection and the
enclosure) with an ohmmeter. Only when there are no abnormal
phenomena anymore, can the machine be used.
Put the machine into the original packing in dry location if it is not to be
used for a long time.
Pay attention to maintenance
Periodic check should be carried out to ensure the long-term normal
use of the machine. Be careful when doing the periodic check,
including the inspection and cleaning of the machine interior.
Generally, periodic check should be carried out every 6 months, and it
should be carried out every 3 months if the cutting environment is
dusty or with heavy oily smoke.
Beware of corrosion
Please clean the plastic parts with neutral detergent.
1.4 Precautions for discard
Pay attention to the following when discarding the cutting machine:
Burning the electrolytic capacitors in the main circuit or on the PCB may cause an
explosion.
Burning the plastic parts such as the front panel may produce poisonous gas.
Dispose it as industrial waste.
https://www.arccaptain.com/
Publicité
