Publicité
2. Select proper working mode and proper
function. There are two working modes
available on the machine panel: 2T and 4T.
3. Push the torch trigger on the cutting
torch, the cutting machine works.
4. Set cutting current according to the
thickness of work piece.
5. Bring the copper nozzle of the cutting
torch into contact with the work piece (For
models with pilot arc function, keep a
distance of about 0.08 inch between the
copper nozzle of the torch and the work
piece.), and then push the torch trigger.
After the arc is ignited and started, raise the
cutting torch to the position about 0.04 inch
above the work piece, and start cutting.
5.3 Notes for cutting operation
WARINING
It is recommended not to ignite the arc in the air if not necessary, for it
will shorten the lifespan of the electrode and nozzle of the torch.
It is recommended to initiate the cutting from the edge of work piece,
unless penetration is needed.
BEWARE OF ELECTRIC
https://www.arccaptain.com/
Pic14:Installation
Pic15:Cutting operation
SHOCK!
Publicité
