Publicité
• The pressure regulator should be set to its lowest setting,
i.e. turned fully counterclockwise.
• If the machine has not been used for more than 24 hours,
open the drain plug ("i" in Fig. 5) to drain any
accumulated condensate. After cleaning the condensed
water, hand tighten the drain plug.
Starting the air compressor
• Make sure the air outlet pressure regulator (8) is closed.
• Turn on the compressor by setting the power switch to
the ON (upper) position, refer to clause 4.3 for details.
• When the air receiver tank is pressurized to its operating
state, the compressor will automatically shut down.
• Check all valves and regulators for leaks.
Connecting accessories and regulating pressure
• WARNING! Do not operate an accessory with pressure greater than the maximum rated
pressure of the accessory.
• Connect the accessory to the quick-lock coupling (9).
• Slowly open the outlet pressure regulator (8) until the pressure gauge (6) indicates minimum
pressure for the accessory.
• Fine adjustments to the air pressure until the accessory is working at its optimum
performance.
After use
• Turn off the compressor by pressing the power switch (5), refer to clause 4.3 for details.
• Disconnect the accessory tool from the compressor, if necessary.
• Turn the regulator (8) counterclockwise all the way and allow the compressor to cool down.
• Release the residual air pressure in the tank by connecting and operation an air duster.
Overload protection
• The compressor is equipped with an overload switch. If the motor becomes too hot, the
overload switch will trip and the equipment will automatically shut down to protect the
compressor from overheating.
• If the overload switch has tripped, turn the power switch (5) to the OFF position and wait for
the compressor to cool before restarting.
VI. MAINTENANCE AND STORAGE
WARNING!
Before any intervention on product, ensure that power is set to the "OFF" position and
disconnect from main power source.
WARNING!
Users should only carry out maintenance work in accordance with this instruction
manual. All other service work must be carried out by an authorized service center.
Reminder: In order to maintain the machine in good working condition, carry out regular
maintenance of the machine after each use and before storage. Any breach or inadequate
maintenance reduces the life of the machine and increases the risk of breakdowns and accidents.
Fig. 5
Page 15 / 28
Publicité
