Publicité
Fig. 2
Fitting the supporting foot (3)
• Fit the supporting foot as shown in Fig. 3.
• "e" denotes nut; "f" denotes supporting foot; "g" denotes bolt.
Fitting the air intake filter (1)
• Fit the air intake filter as shown in Fig. 4.
• "h" denotes air intake filter.
Power supply
• Use the original power cord and plug supplied with the product.
• The compressor must be connected to the 220-240V ~ 50Hz mains supply.
• Long cables, extensions, cable reels... etc. cause a drop in input voltage and can impede
motor start-up.
• In case of ambient temperature below +5 °C, motor start-up is jeopardized as a result of
stiffness.
4.3- Power On/Off
• To turn on the compressor, turn the power switch (5) to the ON (upper) position.
• To turn off the compressor, turn the power switch (5) to the OFF (lower) position.
V. OPERATION
5.1- Intended use
The air compressors are intended for generating and supplying compressed air to pneumatic
power tools and tyres. They are not suitable for inflating small-volume items or continuous
operation. They are designed for private domestic use only, not for artisanal, commercial,
professional and/or industrial use.
NOTE: The compressors are intended for compressing atmospheric air only and strictly
prohibits compressing any other gases.
5.2- Operation
Preparation for use
Before connecting the compressor to the mains, check the following points:
• Mains voltage is 220-240V ~ 50Hz.
• The power switch is in the OFF (lower) position.
• Install the compressor in the vicinity of the point of consumption.
• Make sure that the intake air is dry and dust free.
Fig. 3
Fig. 4
Page 14 / 28
Publicité
